Pioneer S-DV370T Operating Instructions Manual page 44

Problem
Color problems occur
ページ ２００７年１月１６日 火曜日 午前１１時５５分
with your monitor after
changing the HDMI
Color setting (page 27).
Error Messages
Message
LINE ON
EXTRAPWR
deo CD player
SND. DEMO
Remedy
６日 火曜日 午前１１時５５分
CANNOT
ted • Clean the disc and align the disc properly in the disc guide.
fter • If the region number on a DVD-video disc does not match the number on the
MUTING
player, the disc cannot be used (see DVD Video regions on page 39). In this
instance, one of the following messages appears on screen: Incompatible disc
STEREO
region number/Can't play disc.
TRAYLOCK
• Allow time for any condensation inside the player to evaporate. Avoid using the
player near an air-conditioning unit.
KEYLOCK
ossible. • If the disc is loaded upside down, reload the disc with label side face up.
USB ERR
• Press  (stop), then  (play) to start playback again.
ck stops
HDMI ERR
nnot be • Switch the power off once, then on again using the front panel
ct ratios; The system automatically switches on and
 STANDBY/ON button.
you'll see the new TV system setting in the
EEP ERR
５分
nceled. • When the power is cut, settings will be canceled.
display after seeing WELCOME.
EXIT
descreen
color. • Check that connections are correct and that plugs are inserted fully.
bars top
• Check the manual of the TV/monitor to make sure the settings are correct.
Media Type
Resetting the system
ched or • The TV Screen setting is incorrect. Set the TV Screen option to match the TV/
DVD/Super VCD/
change. monitor you're using (see Video Output settings on page 27).
Use the front panel controls to reset all system
escreen
Video CD/DivX
settings to the factory default.
d on a t and right • This system uses copy-protection technology which may prevent recording or
Video
e picture
through cause picture problems when connected through a VCR or AV selector. This is not
With the system on, press  STANDBY/
• CD/MP3/WMA/
ally see
there is a malfunction.
MPEG-4 AAC/
ON while holding down  USB.
the
JPEG/no disc
The next time you switch on, all the system
e.
settings should be reset.
ance • This player is compatible with Macro-Vision System copy guard. Some discs
ion
Switching off the demo
k or dark. include a copy prevention signal, and when this type of disc is played back, stripes
UTO, and
Setting the Key Lock
etc., may appear on some sections of the picture depending on the TV. This is not a
Follow the steps below to switch the automatic
istorted
malfunction.
demo feature off (this starts when you plug in
You can disable the front panel buttons by
leave it
• Discs respond differently to particular player functions. This may result in the
for the first time):
44
alDisc playback switching the Key Lock feature on.
tion with
screen becoming black for a brief instant or shaking slightly when the function is
c is a new two -sided disc, one side 1 With the unit in standby, press SETUP.
ch your
executed. These problems are largely due to differences between discs and disc
1 With the system in standby, press SETUP
ontains DVD content video, audio,
Use / to choose DEMO then press
this may
and use / to choose KEYLOCK then press
2
content and are not malfunctions of this player.
he other side contains non-DVD
ch. See
ENTER.
ENTER.
erence in • DVDs and CDs use different recording methods. This is not a malfunction.
ch as digital audio material.
ible with
Use / to select DEMO OFF and press
This is shown in the front panel display.
3
olume.
2
VD, audio side of the disc is not
ENTER.
Downloaded From TheatreSystem-Manual.com Manuals
s not • Make sure that the CD-ROM was recorded using the ISO 9660 disc format. See
with the CD Audio specification and
En
en press Disc compatibility table on page 36 for more on disc compatibility.
DivX VOD
may not play.
Remedy
• Depending on the connected equipment, some HDMI Color settings may cause
the picture to be displayed incorrectly. In this case, use the TV's own video input
settings to select RGB, if possible. Alternatively, revert to the previous HDMI Color
setting.
Description
• An operation is prohibited because the Line Out mode is on (page 33).
• You cannot adjust SFC Modes or tone controls (bass, treble, and bass boost)
when using EXTRA PWR mode.
• The sound demo is on. See General in Troubleshooting on page 41.
• An operation is prohibited because DVD/CD or USB isn't selected, headphones
are connected, or TEST TONE is pressed during disc playback.
• An operation is prohibited because the sound is muted (press MUTE).
• An operation is prohibited because the DVD/CD or USB function isn't selected.
• The tray lock is on. See General in Troubleshooting on page 41.
• The key lock is enabled. See Setting the Key Lock below.
• See Important in Using the USB interface on page 23 for more on this.
• See HDMI connection above for troubleshooting tips. See also Resetting the
HDMI connection on page 34 if the problem persists.
• Contact your Pioneer authorized service center or your dealer for servicing.
3
• Appears when a menu is automatically exited after a set period of inactivity.
Player setting
Format NTSC PAL AUTO
NTSC NTSC PAL NTSC
PAL
NTSC PAL PAL
—
NTSC PAL NTSC or
PAL
Use / to select LOCK ON or LOCK OFF
2
then press ENTER.
Using the language code list
Some of the language options (see Language
settings on page 28) allow you to set your
preferred language from any of the 136
languages in the Language code list below.
1 Select 'Other Language'.
Use / to select either a code letter or
2
a code number.
Use / to select a code letter or a code
3
number.
See the Language code list below for a
complete list of languages and codes.