Sony WX-800UI Operating Instructions Manual page 16

MP3/WMA/AAC files take longer to play than
others.
 The following discs take a longer time to start
playback.
 A disc recorded with a complicated tree
structure.
 A disc recorded in Multi Session.
 A disc to which data can be added.
The sound skips.
 Defective or dirty disc.
USB device playback
You cannot play items via a USB hub.
 This unit cannot recognize USB devices via a USB
hub.
A USB device takes longer to play.
 The USB device contains files with a complicated
tree structure.
The sound is intermittent.
 The sound may be intermittent at a high-bit-rate.
 DRM (Digital Rights Management) files may not
be playable in some cases.
Audio file cannot be played.
 USB device formatted with file systems other
than FAT16 or FAT32 are unsupported.*
* This unit supports FAT16 and FAT32, but some USB
device may not support all of these FAT. For details,
refer to the operating instruction of each USB device
or contact the manufacturer.
Error displays/Messages
CD ERROR: The disc cannot be played. The disc will
be ejected automatically.
 Clean or insert the disc correctly, or make sure the
disc is not blank or defective.
CD NO MUSIC: There is no playable file. The disc
will be ejected automatically.
 Insert a disc containing playable files (page 13).
CD PUSH EJT: The disc could not be ejected
properly.
 Press  (eject).
HUB NO SUPRT: USB hubs are not supported.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start playback.
NO AF: No alternative frequencies.
 Press SEEK +/– while the program service name is
flashing. The unit starts searching for another
frequency with the same PI (program
identification) data ([PI SEEK] appears).
16
GB
NO TP: No traffic programs.
 The unit will continue searching for available TP
stations.
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SOURCE to
select another source.
 The USB device has a fault, or an unsupported
device is connected.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable files
(page 14).
USB NO SUPRT: The USB device is not supported.
 For details on the compatibility of your USB
device, visit the support site on the back cover.
or
the end of the disc has been reached.
: The character cannot be displayed.
For steering wheel remote control
operation:
ERROR: An error occurred during the function
registration.
 Register again from the function where the error
occurred (page 10).
TIMEOUT: The function registration failed due to a
timeout.
 Try completing the registration while [REGISTER]
is blinking (about 6 seconds) (page 10).
If these solutions do not help improve the situation,
consult your nearest Sony dealer.
If you take the unit to be repaired because of CD
playback trouble, bring the disc that was used at
the time the problem began.
: The beginning or