Husqvarna AR19 Operator's Manual page 35

Replacing the rear wheels
Applies to model AR19.
1. Make sure the machine is parked on level
ground and that the engine is off.
2. Lower the rear wheel control so that the lawn
aerator is resting on the tines.
3. Turn the depth adjustment knob for rear wheel
depth/stability clockwise so that the rear wheels
are set at minimum depth (= increased
stability).
4. Remove the axle nut and washer. Pull out the
axle bolt and remove the wheel from the wheel
carriage.
5. Install the new wheel with the grease nipple
turned outwards and the seals carefully in place
on the wheel bushing. Insert the axle bolt
through the wheel and the wheel carriage. Fit
the washer and nut and tighten firmly.
6. Grease the wheel bearings.
Applies to model AR25.
1. Make sure the machine is parked on level
ground and that the engine is off.
2. Lower the rear wheel control so that the lawn
aerator is resting on the tines.
3. Turn the depth adjustment knob for rear wheel
depth/stability clockwise so that the rear wheels
are set at minimum depth and increased
stability.
4. Remove the hairpin cotter pin (1).
5. Remove the wheel and axle assembly from the
machine (2).
6. Refit the hairpin cotter in the axle to prevent
loss.
MAINTENANCE
8011-176
8011-096
English – 33