Related Manuals for David White 4200H
Summary of Contents for David White 4200H
- Page 1 4200H 4200HV 4200H 4200HV 90° 45° 10° 180° FOR CUSTOMER SERVICE, PARTS AND REPAIR CALL (765) 581-4097 www.davidwhite.us.com IMPORTANT: IMPORTANT: IMPORTANTE: Read Before Using Lire avant usage Leer antes de usar...
- Page 2 David White is not responsible for errors caused by instruments that are out of adjustment. Contact your distributor, dealer or David White for information on the nearest facility to check if your instrument is properly adjusted.
- Page 3 4200HV 90° 45° 10° 180° 4200HV 90° 45° 10° 180°...
- Page 4 4200H 4200H...
-
Page 5: General Safety Rules
GENERAL SAFETy RULES Read all instructions. Failure to follow all instructions listed WARNING below may result in hazardous radiation exposure, electric shock, fire and/or serious injury. If glass light house breaks when dropped, contact customer service immediately. Broken glass can cause laceration hazard and unit to lose its IP rating. -
Page 6: Electrical Safety
Work area safety DO NOT dispose of batteries in fire. Keep batteries out of reach of Keep work area clean and well children. lit. Cluttered or dark areas invite accidents. Personal safety DO NOT operate the laser tool around Stay alert, watch what you are children or allow children to operate doing and use common sense the laser tool. -
Page 7: Intended Use
or transits to view the laser beam. Do not use the tool if the switch does Serious eye injury could result. not turn it on and off. Any tool that cannot be controlled with the switch DO NOT stare directly at the laser is dangerous and must be repaired. -
Page 8: Technical Data
Carrying Handle Indicator Reception Sensors for Remote 3c. ADS button with Indicator Control 3d. Slope Adjustment Buttons Window for Plumb Beam TECHNICAL DATA 4200H 4200HV Description Accuracy, Horizontal leveling 1/8-in at 100-ft 1/8-in at 100-ft (3mm at 30m) (3mm at 30m) -
Page 9: Inserting/Replacing Battery
4200H 4200HV Description Slope/Grade Capability Dual (±10.00%) Dual (±10.00%) Power Supply 4-C Cell, NiMh 4-C Cell, NiMh Rechargeable Approx. Rechargeable Approx. 50hr.(Ni-MH); 50hr.(Ni-MH); Approx. 40hr (Alkaline) Approx. 40hr (Alkaline) Water/Dust Protection IP55 IP55 Dimension 6.3 x 6.3 x 7.8-in 6.3 x 6.3 x 7.8-in... -
Page 10: Operation
instrument, recharging takes up Charging Rechargeable to 8 hours (4 x 5000 mAh Ni-Mh NiMh Battery Pack batteries). Insert the charger into the outlet and the charging port of the instrument Power required for the charger: or the battery pack. The charger LED Frequency: 50-60HZ;... -
Page 11: Operation Modes
Switching On and Off self-leveling, the laser instrument will begin operating in Rotation Mode at Press the Power ON/OFF 3a keypad the speed of 600 RPM. and allow the laser instrument to self-level. If the power indicator LED If the instrument is placed improperly, blinks, the voltage of the batteries or the slope of instrument exceeds is low and batteries need to be... - Page 12 90° Smart H.I. Alert System (ADS) 45° 10° 180° Enable to the ADS system 3c to alert user when laser has been disturbed. Press the ADS button to activate. 4200HV 90° 10° 45° 180° When the LED is blinking slowly, the laser is in H.I Alert mode.
-
Page 13: Accuracy Check
ACCURACy CHECK The ambient temperature has near wall. Switch the instrument the greatest influence. Especially on. Position the X-axis to aim to a temperature differences occurring wall or target plate. from the ground upward can divert the laser beam. The deviations play a role in excess of approx. - Page 14 Repeat the measuring procedure for If the instrument should exceed the Y-axis. Position the Y-axis to aim the maximum deviation in anyone 165-ft (50 m) 165-ft (50 m) to a wall or target plate. of the measuring procedures, have it checked at a SitePro after-sales 180°...
- Page 15 – The mark of point H3 should be allow it to level and mark the 1.5-ft 1.5-ft center point of the laser beam on marked in such a way that it is as 100-ft (30 m) 100-ft (30 m) (0.5 m) (0.5 m) wall B (point H2).
- Page 16 RC420 REMOTE CONTROL The 4200HV includes a remote The remote control can be used control. up to a maximum of 100 feet (30m) away from the instrument. Have the remote WARNING control repaired only through a qualified repair person and only using identical replacement parts.
- Page 17 Audio signal indicator Spirit level 3g. Battery low indicator Speaker Reception area for the laser beam Audio signal button Button for adjustment of measuring Locking screw for leveling rod accuracy 10. Magnetic mounts LD20 LD20 PREPARATIONS Inserting/Replacing the Battery Remove the battery when not using it for extended periods.
-
Page 18: Maintenance And Service
LIMITED WARRANTy Dave White’s SitePro (“Seller”) warrants to the original purchaser only, that all David White laser tools and optical instruments will be free from defects in material or workmanship for a period of two (2) years from date of purchase. - Page 19 THIS LIMITED WARRANTY APPLIES ONLY TO PRODUCTS SOLD WITHIN THE UNITED STATES OF AMERICA, CANADA AND THE COMMONWEALTH OF PUERTO RICO. FOR WARRANTY COVERAGE WITHIN OTHER COUNTRIES, CONTACT YOUR LOCAL SITEPRO DEALER OR IMPORTER. David White is a registered trademark and offered exclusively by SitePro. -19-...
- Page 20 © Dave White’s SitePro 7619 S 1150 E Otterbein, IN 47970 Tel. +1 (765) 581 4097 42348D4200 09/15 Printed in China...