Drive Select Switch (Pz50Rt / Pz50Gt / Pz50Mt / Pz50Vt); Engine Stop Switch - Yamaha Phazer PZ50Y Owner's Manual

ror code will flash slowly in the tripme-
ter/odometer display. Note the error code,
and then have a Yamaha dealer inspect the
snowmobile as soon as possible. NOTICE:
Do not continue to operate the engine
longer than necessary if there is an error
code to avoid possible engine damage.
[ECS00820]
1. Warning light "
2. Self-diagnosis warning indicator "
3. Two-digit error code
ESU10544
Drive select switch (PZ50RT /
PZ50GT / PZ50MT / PZ50VT)
The drive select switch is used to shift the
snowmobile into drive or reverse. After com-
ing to a complete stop, press the drive select
switch.
The drive "D" indicator light comes on when
the transmission is in drive (forward).
The reverse "R" indicator light comes on when
the transmission is in reverse.
"
"
Control functions
1. Drive select switch (PZ50RT / PZ50GT /
PZ50MT / PZ50VT)
2. Drive "D" indicator light (PZ50RT /
PZ50GT / PZ50MT / PZ50VT)
3. Reverse "R" indicator light (PZ50RT /
PZ50GT / PZ50MT / PZ50VT)
ECS00052
NOTICE
Do not use the drive select switch while
the snowmobile is moving. Otherwise, the
drive train could be damaged.
ESU10531

Engine stop switch " "

The engine stop switch is used to stop the en-
gine in an emergency. Simply push the stop
switch to stop the engine. To start the engine,
pull the stop switch and proceed with starting
the engine. (See page 36 for engine starting
procedures.)
1. Engine stop switch "
During the first few rides, practice using the
stop switch so that you can react quickly in an
emergency.
"
17