Customer Warranty; Mute; Quiet Drive; Battery Voltage - Cobra RAD500G Operating Instructions Manual

Main Icons
Settings
Your Detector
Intro Operation Customer Warranty
MUTE Button
Assistance
Manual Mute: Your detector allows you to quickly turn OFF an audio alert by
momentarily pressing the MUTE button. If you press the MUTE button a second
time during the alert, the audio alert will be turned back ON. When an alert is
being muted the audio icon on the display will change to
Secondary Icons
Notice
Quiet Drive is a muted driving mode for times when a driver wants less audible
feedback while talking with passengers, on the phone, etc. Only the first few
seconds of audio will be heard. This mode is Off by default.
This mode can be changed in the User Settings menu or by pressing and holding
the MUTE button for two seconds. When Quiet Drive is on the audio icon on the
display will change to

Battery Voltage

To display your vehicle's battery voltage, press the MUTE button momentarily
while no signal is being detected.
DIM Button
You can choose from four settings for the brightness of the display. Repeatedly
push the DIM button to cycle through the settings. The factory setting is Bright.
6 English
RAD500G_MANL.indd 6-7
Main Icons
Settings
Your Detector
Intro Operation Customer Warranty
Menu - User Settings
Assistance
To change the User settings, enter the Menu by pressing the MENU button. A voice
announces "Menu" and the display will change to
USER GPS
Secondary Icons
Press the DIM button to enter the User settings menu.
Press the MUTE or MENU buttons to switch between the User settings.
Press the DIM or SEN buttons to change the selected User setting's value.
Notice
The value that is shown on the display is the selected value. To exit the menu
simply wait several seconds or select Exit Menu.
USER SETTING VALUE

Detail

More*/Less

Quiet Drive

Off*/On
Auto Mute Off/On*
Voice Off/On*
Language English*/Spanish
Screen Saver Off / 1 Minute* / 3 Minute
Smart Power Off*/On
Display Car Voltage Off*/On
System Info Press the SEN button to display system information.
Restore Defaults
Press the SEN button to restore factory default settings
then press SEN button again to confirm (not displayed
until a setting has changed).
Exit Menu Press the MUTE button to exit the menu.
* = Factory default setting
Detail
In the More detail mode, information about the radar band, signal strength and
frequency will be displayed.
In Less detail mode, only the threat level is displayed (see page 10).
•
ALERT
Nothing Comes Close to a Cobra 7
®
4/20/17 4:04 PM