Screen Saver; Smart Power; Low Car Voltage; System Info - Cobra RAD450 Operating Instructions Manual

Settings
Your Detector
Intro Operation Customer Warranty
Menu - Radar Settings continued
Assistance
RADAR SETTING VALUE
X Band Off/On*
K Band
Secondary Icons Off/On*
Ka Band Off/On*
VG-2 Off*/On
Spectre Off*/On
Notice
Exit Menu Press the MUTE button to exit the menu.
* = Factory default setting
Detail
In the More detail mode, information about the radar band, signal strength and
frequency will be displayed.
In Less detail mode, only the threat level is displayed (see page 10).
AutoMute
AutoMute will automatically reduce the audio volume of all alerts after four
seconds for as long as the signal is detected. The factory setting for AutoMute
is On.
Language
The detector can be set to either English or Spanish for all text and voice audio.
IntelliMute
INTELLIMUTE allows you to avoid alerts you don't need to hear because you are
stopped or moving slowly. By sensing the "revs" (RPMs) of your engine, INTELLIM-
UTE knows when you are at low speed and automatically mutes alerts (except for
strobe signals from emergency vehicles).
Before INTELLIMUTE will work, you must set an activation point for your engine's
revs. Whenever the revs are below that point, INTELLIMUTE will begin muting.
The activation point will be stored in memory and recalled each time the power is
turned On. The factory setting is INTELLIMUTE Off.
NOTE: INTELLIMUTE may not work with some vehicles because it cannot sense
the engine's revs. In such cases, you can reduce unwanted audio alerts
by using Auto Mute and SEN mode when appropriate.
8 English
Settings
Your Detector
Intro Operation Customer

Screen Saver

Assistance
•
Your detector has a SCREEN SAVER mode. When SCREEN SAVER is turned On
(factory default is 3 minutes), the screen will change to Dark from it's Bright,
Dim, or Dimmer setting after the time interval selected. While the screen is Dark,
the scanner will be displayed dimly.
Secondary Icons
NOTE: While SCREEN SAVER is activated, any alert will turn the display back on
at the last brightness setting (Bright, Dim or Dimmer). Touching any button will
also turn On the display.

Smart Power

Notice
Your detector includes the SMARTPOWER feature that, when turned On, will put the
unit into Low Power mode 15 minutes after the car's engine has been turned Off.
Before SMARTPOWER enters Low Power mode, you will hear three beeps and
SMARTPOWER will flash on the display. To return the unit to Normal Power mode
and exit Low Power mode, start the car, press any button or turn the unit Off and
then On again.

Low Car Voltage

Displays your car battery voltage and automatically warns you if this drops
below 11.9V. Your detector will then shut off to prevent further draining of
your car battery.

System Info

Displays information about the versions of software/firmware that are
installed on your detector.

Restore Defaults

To return your detector to factory default settings, press the SEN Button.
Press the SEN Button again to confirm that you want to restore factory
settings. Press the MUTE Button to exit.
Warranty
Nothing Comes Close to a Cobra 9
®