Brother PT-9600 User Manual page 89

ERROR MESSAGE
SET STAMP-M!
TAPE END!
TEXT TOO HIGH!
TEXT TOO LONG!
VALUE OUT OF RANGE!
CHECK VALUE AND
RE-ENTER.
CAUSE
● This message appears if a 3/4"
(18-mm)-wide stamp tape cas-
sette is not installed when print-
ing an Auto format template
created for a STAMP M stamp.
● This message appears if the end
of the tape in the cassette has
been reached.
●
This message appears if the size
of the text is larger than the
width of the installed tape.
● This message appears if the
Lines of Text setting for the ESC/
P interface mode exceeds the
maximum possible for the
installed tape.
● This message appears if the
length of the text is longer than
the label length that has been
set with the Tape Length func-
tion.
● This message appears if you try
to print a label that is longer
than the maximum label length.
● This message appears if you try
to print a label that is longer
than the maximum label length
or is longer than the specified
block length.
● This message appears if the
length of the text is longer than
the width of the tape when the
Text Rotation function is used.
● This message appears if the
value entered while setting the
Tape Margin, Tape Length,
Block Margin and Block Length
function is not within the allow-
able range.
● This message appears if the
specified characters cannot be
found in the database.
● This message appears if the val-
ues for the records to be printed
is not within the allowable
range.
ERROR MESSAGE LIST
SOLUTION
● Install an 3/4" (18-mm)-
wide stamp tape cassette.
● Replace the tape cassette,
and then, after closing the
tape compartment cover,
press any key.
●
Reduce the size of the
characters, install a tape
with a greater width or
select the AUTO text size
setting.
● Specify the correct setting
for the installed tape.
● Press e, and then use
the AUTO Size setting to
format a label with a spe-
cific length, as described
in the example on
page 23.
● Type in a value that is
within the allowable
range.
75