Brother PT-9600 User Manual page 46

Ch. 3 Functions
1 2 3 4 5 6 7 8 9
R
R
G
11/13
R
H NO
R
B. MARGIN
L
R
I
M
AUTO
R
J
AUTO 1.10
Length Margin
3 Press m or g until the desired setting is
displayed, or use the number keys to type in
the desired block margin width.
NOTE
☞
To return the function to its default setting
(AUTO), press the space bar.
☞
To change the setting in 0.1" (1.0 cm) steps,
hold down either m or g, and then release
the key when the desired setting is displayed.
☞
The block margins are displayed in the cur-
rently selected unit of measurement (inches or
centimeters). The unit of measurement can be
changed with the Setup functions. (Refer to
page 68.)
☞
To return to the text without changing the for-
e
matting, press
1
press ).
4 Press n to apply the setting.
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
Block Length function
(B. LENGTH)
Normally, the length of each text block auto-
matically adjusts to fit the length of the entered
text. However, with the Block Length function,
you can set each text block to a length between
0.25" and 38.84" (0.6 cm and 99.5 cm).
32
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
d
(OR hold down and
To change the setting for the Block Length
function:
1 Hold down d and press 1 or 2.
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
2 Press j or k until B. LENGTH is dis-
played. The current setting is shown on the
left side of the display.
1 2 3 4 5 6 7 8 9
R
R
G
12/13
R
H
NO
R B. LENGTH
L
R
I
M
AUTO
R
J
AUTO 1.10
Length Margin
3 Press m or g until the desired setting is
displayed, or use the number keys to type in
the desired block length.
NOTE
☞
To return the function to its default setting
(AUTO), press the space bar.
☞
To change the setting in 0.1" (1.0 cm) steps,
hold down either m or g, and then release
the key when the desired setting is displayed.
☞
The block length is displayed in the currently
selected unit of measurement (inches or centi-
meters). The unit of measurement can be
changed with the Setup functions. (Refer to
page 68.)
☞
To return to the text without changing the for-
e
matting, press
1 2
press or ).
4 Press n to apply the setting.
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
d
(OR hold down and