Husqvarna 525RJX Operator's Manual page 17

(2) Choke: Move choke control up to choke position.
WARNING! When the engine is started
!
with the choke in either the choke or
start throttle positions the cutting
attachment will start to rotate
immediately.
Hold the body of the machine on the ground using your
left hand (CAUTION! Not with your foot!).
(3) Grip the starter handle, slowly pull out the cord with
your right hand until you feel some resistance (the starter
pawls grip), now quickly and powerfully pull the cord.
Never wrap the starter cord around your hand
Repeat pulling the cord until engine attemps to start (or
maximum 5 pulls).
(4) Move choke control down to run position.
(5) Pull the cord until engine starts and gradually operate
throttle trigger for increasing engine speed to operate
speed. The throttle will automatically disengage from the
start setting.
Warm engine
(1) Air purge: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
(5) Pull the cord until engine starts and gradually operate
throttle trigger for increasing engine speed to operate
speed.
1154813-49 Rev. No 1 2015-06-15
STARTING AND STOPPING
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
CAUTION! Do not put any part of your body in marked
area. Contact can result in burns to the skin, or electrical
shock if the spark plug cap has been damaged. Always
use gloves. Do not use a machine with damaged spark
plug cap.
Stopping
The engine is stopped by pushing the stop switch to the
stop position.
CAUTION! The stop switch automatically returns to the
start position. In order to prevent unintentional starting,
the spark plug cap must be removed from the spark plug
when assembling, checking and/or performing
maintenance.
–
English 17