I N S TA L L AT I O N G U I D E SUPPORTED MODEL - X2-__-AC-JB-1-__-____ - KetraNet Mesh Keypad 120-277V *Available in multiple button layouts and colors. Refer to specifications sheet. INSTALLATION GUIDE 770-000026-01-01 PAGE 1...
WAR N I N G Shock Hazard. May result in serious injury or death. Turn power OFF at circuit breaker or remove fuse. Damage to this product caused by wiring with power on voids the warranty. Due to risk of electric shock, a licensed electrician should install this power supply unit in strict compliance with the National Electric Code and any state or local code which may apply.
TA B LE O F CO NTE NT S Cover Page....................page 1 Warning....................page 2 Table of Contents................... page 3 Product Overview.................. page 4 Included Components................page 5 Specifications..................page 5 Dimension Drawings................page 6 Wiring Diagrams..................page 6 Installation.....................
Ketra’s X2 keypad offers a classic button-style interface for the complete control of a lighting system. Each button is fully programmable, storing a scene that can be relayed wirelessly to Ketra devices on the control network. Fitting within a standard wall box and either Decora® or Claro wall plates, the X2 is perfect for retrofit installations as well as new construction.
I N CLU D E D CO M P O N E NT S X2.D.ELV SN: KX12345678 DC: V0216 X2 with Wall Plate Single Gang Button Chassis Mount Wall Plate X2.D.ELV SN: KX12345678 DC: V0216 (2) #6-32 x 1/4” Serial (2) #6-32 x 1”...
I N S TA LL ATI O N X2-_ _-AC-JB-1-_ _-_ _ _ _ New Construction 1. Install wall box (at least 14 in3 volume per gang). 2. If installing in a multigang box, the side-fins must be removed for fit. (See Fig 1 and 2) 3.
Page 8
I N S TA LL ATI O N 6. Ensure that no conductors are visible after insertion, and that no stray wires are exposed. 7. Carefully tuck wires back into wall box. 8. Mount the X2 to the wall box using the supplied fasteners. Leave the fasteners snug, not fully tight.
Page 9
• Wall box should have volume of 14 in or greater. • The X2 does not have to be on the same circuit as the Ketra fixtures it will control, as the control signal is wireless. • Ketra fixtures to be controlled by the X2 should have an uninterrupted source of power.
R E PL ACI N G B U T TO N CH A S S I S The X2’s button chassis can be replaced. The replacement chassis must have the same button layout as the original. To replace the button chassis, follow these steps: 1.
R E PL ACI N G B U T TO N CH A S S I S 6. Apply replacement button chassis immediately, applying equal pressure to all four corners to ensure that the new chassis snaps into place. Note: Your replacement chassis must have the same button layout as the original. 7.