INTRODUCTION Thank you for your purchase of the Orion P-Series Component Loudspeaker system. These speakers represent a combination of incredible performance and value. The P- series die-cast components feature aluminum-treated polypropylene cones and vapor- deposit titanium dome tweeters. Capable of maintaining their balance and clarity at exceptionally high output levels, they are the perfect complement to the P-series or H2 subwoofers.
INSTALLATION The performance of the P-Series Component Loudspeaker is directly proportional to the quality of installation. Care taken during the installation process will be rewarded with years of satisfying performance. If you are unsure about your installation capabilities, please refer to your local Authorized Orion Dealer for technical assistance.
REAR DECK MOUNTING In rear deck installations, check the operation of the trunk suspension springs or tension bars. These tension bars move in the opening and closing of the trunk. You cannot be too cautious during this part of the installation, In addition, do not locate the speakers too close to the back of the rear deck.
Step 9: Mount the speaker- The speaker is placed in the grille ring from the front. Place the speaker and the grille ring in the installa- tion hole. Align the mounting screw holes and drive in the four mounting screws. Push the perforated metal grille back into the grille ring.
Page 6
FLUSH MOUNTING INTO REMOVED PANELS Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. Step 2: Mark the center point of the tweeter location. Step 3: If using a hole saw, first drill a pilot hole, then cut out the hole using a standard 2-1/8"...
Sensitivity Mounting Depth Mounting Diameter T T W W E E E E T T E E R R W W O O O O F F E E R R Orion P5.2 Orion P6.2 4 ohms 4 ohms 100/150...
Page 8
Warranty LIMITED TWO YEAR CONSUMER WARRANTY: Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase from the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer.