GE GSC820 Use And Care Manual page 14

HOW TO CHANGE COLOR PANELS
If you are redecorating, you can change your
dishwasher's front panels to match or blend with your
new colors.
How to change door panel insert:
1. Take out trim screws on either side of the
dishwasher door. Remove the side trim.
2. Slide the door panel out.
(Careful—edges may be sharp.)
3. Turn the door panel around and put the color you
want in front.
4. Replace the door panel, side trim and screws.
How to change the lower panel:
1.
Remove the panel attachment screws.
Attachment Screws
Wood panels
A wood panel trim kit, GPF 40, contains trim and
instructions for adding a decorative wood door panel
and lower access panel no thicker than 1/4" to match
kitchen cabinets. The kit is available at no extra cost.
(Specify GPF40).
1A
The panel is held in place by the door trim and the
trim on the panel below the door. Each side of each
panel is a different color. Or you can paint a panel
with the color of your own choice.
2. Remove the entire access assembly by lifting it up
and over the retaining tabs.
3. Take out the top trim screws and remove the
top trim.
4. Slide the color panel (s) up and out and put the
color you want in front.
5. Replace the top trim and screws.
6. Replace the entire access assembly by hanging it
back on the retaining tabs and replace the
attachment screws.
Use the order form on the next page to order,
without charge, a color panel not supplied with
your dishwasher or a wood panel trim kit GPF40.
NOTE: Do not operate
dishwasher while changing
panels or when lower access
panel is removed.