Electrical Requirements - GE GSC820 Use And Care Manual

How to disconnect the Unicouple from faucet adapter
1. Turn off the hot water.
2. Release the water pressure by depressing
the pressure release button. This relieves
water pressure and protects you, and the
room, from severe splashing.
How to disconnect your dishwasher
1. Remove the power cord plug from the wall
receptacle.
2. Disconnect Unicouple from faucet adapter.
How to drain excess water from Unicouple hoses
If the sink is 34" or higher from the floor,
the excess water in Unicouple hoses cannot be
drained directly into the sink. It will be necessary to
drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
HOW TO CONNECT ELECTNCITY
Caution, for personal safety:
DO NOT USE AN EXTENSION CORD OR
AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD.
Dishwasher must be electrically grounded in accordance with local codes and ordinances, or in the
absence of local codes, in accordance with the NATIONAL ELECTRICAL CODE, ANS~FPA NO. 7&1987.

Electrical requirements

This appliance must be
supplied with 120V, 60 Hz,
and connected to an individual,
properly grounded branch circuit,
protected by a 15 or 20 amp circuit
breaker or timedelay fuse.
If the electric supply
provided does not meet the above
specifications, it is recommended
a licensed electrician install
that
an approved outlet.
3. Release Unicouple from faucet by depressing
the collar at the top of the Unicouple connector.
NOTE: When motor stops at the end of the
final rinse, the Unicouple can be disconnected
and returned to storage.
o .0
INSURE PROPER
GROUND EXISTS
BEFORE USE
Your dishwasher circuit
should not be used for any
other appliance while the
dishwasher is in operation as
the dishwasher requires the full
capacity of the circuit.
If the wall receptacle you
plug the dishwasher's power
cord into is controlled by a
switch, turn on the switch.
5