The term “power tool” in the warnings refers to your mains-operated (corded) power Definitions: Safety Guidelines tool or battery-operated (cordless) power tool. 1) WORK AREA SAFETY The definitions below describe the level of severity for each signal a) Keep work area clean and well lit. Cluttered or dark areas invite accidents. word.
b) Use personal protective equipment. Always wear eye protection. Protective e) Maintain power tools. Check for misalignment or binding of moving parts, equipment such as dust mask, non-skid safety shoes, hard hat, or hearing breakage of parts and any other condition that may affect the power tool’s protection used for appropriate conditions will reduce personal injuries.
MINIMUM GAUGE FOR CORD SETS • crystalline silica from bricks and cement and other masonry products, and For Cable length (m): 7.5 • arsenic and chromium from chemically-treated lumber (CCA). Use Cable with minimum rating (Amperes) Your risk from these exposures varies, depending on how often you do this type of Tool Amperes work.
Residual Risks COMPONENTS (Fig. 1) T he following risks are inherent to the use of drills: WARNING: Never modify the power tool or any part of it. Damage or personal – Injuries caused by touching the rotating parts or hot parts of the tool. injury could result.
OPERATION 2. Insert the bit or other accessory about FIG. 2 19 mm (3/4") into the chuck and tighten WARNING: To reduce the risk of serious personal injury, turn tool off and securely by holding the rear half of the disconnect tool from power source before making any adjustments or removing/ chuck and rotating the front portion in the installing attachments or accessories.
DRILLING IN WOOD WARNING: To reduce the risk of personal injury, ALWAYS ensure workpiece is anchored or clamped firmly. If drilling thin material, use a wood “back-up” block to Start drilling with slow speed and increase to full power while applying firm pressure prevent damage to the material.
ACCESSORIES NOTE: Three Year Warranty is not applicable to items deemed as consumables. Radial arm saws are covered by a one (1) year warranty only. D WALT Reserves the right to WARNING: Since accessories, other than those offered by D WALT, have not been review its warranty policy prior to launch of any new business development products.