Cassette Tape - Panasonic SC-PM45 Operating Instructions Manual

South East Asia only

Cassette tape

PLAY MODE
CLEAR 7
Basic play Basic play
Press [0] on top of the unit.
1
2 Insert the cassette.
3 Close the lid by hand.
Press [TAPE 3] to start play.
4
To play the other side of the cassette, turn the cassette
over.
To
stop tape playback
start one-touch play
fast-forward and
rewind
Note
• Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
• Endless tapes can get caught up in the deck's moving parts if used
incorrectly.
TPS (Tape Program Sensor) TPS (Tape Program Sensor)
This function enables you to search the beginning of a track,
up to a maximum of 9.
Press [ /REW/4] or [ /FF/¢] during play.
Play resumes from the track found.
Note
TPS may not function properly:
• with short silent parts
10
• when noise occurs between tunes
• if silent parts are found within tunes
PM45_GN-En_new.indd 10 PM45_GN-En_new.indd 10
CD 6
CLEAR
USB
USB 6
TAPE 3
TAPE
/REW/4,
/FF/¢
¶ REC/
Insert inside the
guides
Forward side
Action
Press [CLEAR 7].
Press [TAPE 3] when the unit is OFF with
the cassette loaded.
Press [ /REW/4] or [ /FF/¢] in the
stop mode.
Recording Recording
Use normal position tapes.
High position and metal position tapes can be used, but this
unit will not be able to record or erase them correctly.
Preparation
Wind the leader tape so that recording can begin
immediately.
1 Insert the cassette to be recorded.
2 Select the source to be recorded.
7
Radio recording:
Tune in the station. ( ➡ page 10)
7
Disc or USB recording:
1 Disc
Insert the disc you want to record.
Press [CD 3/
USB
Connect the USB mass storage device. ( ➡ page 13)
8
Press [USB 3/
2 Prepare the desired recording mode.
To
record
programmed
tracks
record
specifi c tracks
7
Music port recording:
Connect the portable audio equipment. ( ➡ page 13)
Press [MUSIC PORT].
Play the portable audio equipment.
3 Press [¶ REC/
To
stop recording
stop recording
temporarily
record on the other
side of the tape
erase a recorded
sound
Erasure prevention Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Side A
Tab for side B Tab for side A
8
CLEAR 7
] and then [ ].
8
] and then press [CLEAR
Action
➡
Program the tracks you want. (
Press [PLAY MODE] to select your desired
➡
mode. ( page 7)
8
] to start recording.
Action
Press [CLEAR 7].
8
/
1) Press [¶ REC ].
2) Press again to resume recording.
Turn the cassette over and press
8
/
[¶ REC ].
1) Insert the recorded cassette.
2) Press [TAPE 3] and then [CLEAR 7].
8
3) Press [¶ REC/ ].
To re-record
Normal tape
Adhesive tape
7
] twice.
page 8)
1/24/07 12:44:21 PM 1/24/07 12:44:21 PM