Parking Brake Adjustment - Yamaha YFM660R Owner's Manual

1. Locknut
A. Cable length
1. Contre-écrou
A. Longueur de câble
1. Contratuerca
A. Longitud del cable
1. Locknut
1. Contre-écrou
1. Contratuerca
2. Adjusting bolt
2. Boulon de réglage
2. Perno de ajuste
2. Adjusting bolt
2. Boulon de réglage
2. Perno de ajuste

Parking brake adjustment

Parking brake adjustment may be required if the
parking brake does not hold properly. The cable
length A should be adjusted to 64–68 mm.
1. Release the parking brake by moving the
parking brake lever to the right.
2. Fully loosen the locknut and the adjusting bolt
at the rear brake caliper.
3. Loosen the locknut on the brake cable.
4. Turn the adjusting nut on the brake cable in
direction a to increase the cable length or in
direction b to decrease the cable length.
NOTE:
_
If the cable cannot be adjusted to specification,
consult a Yamaha dealer.
_
5. Tighten the locknut on the brake cable.
6. Screw in the adjusting bolt at the rear brake
caliper until it feels tight, and then screw it out
1/8 turn. Tighten the locknut to the specified
torque.
8-79
EBU14751