Yamaha FJR1300A Owner's Manual page 29

"TRIP-1" and "TRIP-2" show the dis-
tance traveled since they were last set
to zero.
When approximately 5.5 L (1.45 US
gal, 1.21 Imp.gal) of fuel remains in the
fuel tank, the last segment of the fuel
meter starts flashing. In addition, the
information display will automatically
change to the fuel reserve tripmeter
mode "TRIP-F" and start counting the
distance traveled from that point.
GEAR
4
TRIP-F km
3.4
In that case, pushing the select switch
switches the display between the vari-
ous information displays in the follow-
ing order;
INSTRUMENT AND CONTROL FUNCTIONS
TRIP-F → Display–1 → Display–2 →
Display–3 → TRIP-F
To reset a tripmeter, use the select
switch to select the information display
that contains the tripmeter. Push the
"RESET" button briefly so that the trip-
meter flashes, and then push the "RE-
SET" button again for at least 2
seconds while the tripmeter is flashing.
If you do not reset the fuel reserve trip-
meter manually, it will reset itself auto-
matically and the display will return to
the prior mode after refueling and trav-
eling 5 km (3 mi).
Estimated traveling range display:
RANGE
11
The distance that can be traveled with
the remaining fuel in the fuel tank under
the current riding conditions is shown.
3-14
Elapsed time display:
TIME TRIP
The time that has elapsed since the
key was turned to "ON" is shown. The
maximum time that can be shown is
99:59.
This display is automatically reset
when the key is turned to "OFF".
TIP
There are also "TIME–2" and "TIME–3"
elapsed time displays, but they cannot
be set to the information display. See
"Setting mode" on page 3-16 for de-
tailed information.
km
Ambient temperature display:
A.TEMP
This display shows the ambient tem-
perature from –9 °C to 50 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
0:06
3
˚C
25