Yamaha FZ6-SHG Owner's Manual page 79

NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
7. Remove the wheel.
CAUTION:
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
To install the rear wheel
1. Install the wheel and the brake cal-
iper bracket by inserting the wheel
axle from the right-hand side.
PERIODIC MAINTENANCE AND MINOR REPAIR
NOTE:
G
Make sure that the retainer on the
swingarm is inserted into the slot in
the brake caliper bracket.
G Make sure that there is enough
space between the brake pads be-
fore installing the wheel.
ECA11070
1. Retainer
2. Slot
2. Install the drive chain onto the rear
sprocket, and then adjust the drive
chain slack. (See page 6-23.)
3. Install the axle nut, and then lower
EAU32940
the rear wheel so that it is on the
ground.
4. Tighten the axle nut to the speci-
fied torque.
6-38
Tightening torque:
Axle nut:
120 Nm (12.0 m·kgf, 85 ft·lbf)
6