Engine Oil - Yamaha BEAR TRACKER YFM250XR Owner's Manual

1. Oil filler cap
3. Maximum level mark
1. Bouchon de remplissage d'huile
3. Repère de niveau maximum
1. Tapa de relleno de aceite
3. Marca de nivel máximo
2. Dipstick
4. Minimum level mark
2. Jauge
4. Repère de niveau minimum
2. Varilla de nivel de aceite
4. Marca de nivel mínimo

Engine oil

Engine oil level measurement
1. Place the machine on a level surface.
2. Warm up the engine for several minutes and
stop it. Wait at least ten minutes for the oil to
drain back into the crankcase before check-
ing the oil level.
NOTE:
_
Be sure to wait at least ten minutes until the oil lev-
el settles before checking.
_
3. Remove the engine oil filler cap and wipe the
dipstick off with a clean rag. Insert the dip-
stick in the filler hole without screwing it in.
4. Remove the dipstick and check the oil level.
5. The oil level should be between the maxi-
mum and minimum marks. If the level is low,
add oil to raise it to the proper level.
6. Install the engine oil filler cap.
CAUTION:
_
Make sure no foreign material enters the
crankcase.
_
8-13
EBU01100