Table of Contents
Advertisement
Section 3 - Setup
Setting up the Network
Your DIB-360 allows you to access the Internet through one of the following connections:
Ethernet Connection
To use the network feature, please connect an Ethernet cable from the Ethernet port on your DIB-360 to a network jack or hub on your network. Go
to Settings -> Network -> Wired, and your device will obtain an IP address automatically. After obtaining an IP address successfully, your DIB-360
can be connected to an Ethernet-based network.
If you want to set the IP address manually, you can select Static to enter the IP Address, Subnet Mask, Router Address, and DNS Address. After
you've completed your settings, you can go to Settings -> Network -> Test Network, and then you can check the status of the network connection.
Wi-Fi Connection
Before trying to activate the Wi-Fi, please make sure your DIB-360 is within antenna range of the network's access point and the wireless access
point is running. You can see the Wi-Fi instructions in the Settings chapter for more information.
Setup Wizard
When you turn on your device for the first time, the Setup Wizard will be launched on the screen. The Setup Wizard will guide you to set up your
device by following a series of simple instructions.
D-Link DIB-360 User Manual
9
Advertisement
Table of Contents
