Move Refrigerator Into Frame; Install Door Panels - KitchenAid KBBX104EPA Installation Manual

Move Refrigerator Into Frame

1. Attach the hinge caps, two on the refrigerator door and two
on the freezer door.
2. Place the gasket on the side of the unit opposite the hinges.
3. Move the refrigerator into the frame.
4. Use a Phillips screwdriver and two 13 mm screws (one for
each side) to attach the brackets at the top of the unit to the
underside of the top of the frame.
5. Use the cabinet alignment tool to make sure that the
refrigerator is pushed into the frame to the proper distance
13¹³⁄₁₆" (46 mm).
6. Use a Phillips screwdriver and two 25 mm screws (one for
each side) to attach the brackets at the base of the unit to
the floor of the frame.
7. Use a Phillips screwdriver and four 13 mm screws (one for
each hinge) to attach the hinges to the side of the frame.
/
1 13 " min.
16
(46 mm)
6

Install Door Panels

Door Panels Requirements (each door)
Max Weight: 26.5 lbs (12 Kg)
Minimum Panels Dimensions:
1
Refrigerator Door Panel: 42
x ¾" (20 mm)
⁄₈" (701.5 mm) x 23¼" (590 mm) x
5
Freezer Door Panel: 27
¾" (20 mm).
1. Mount the panel alignment tool onto the refrigerator door.
■ Align the smaller piece with the screws on the bottom of
the door, and slide it to the left (step 1 and 2 in picture
above).
■
Assemble the panel alignment tool by inserting the long
arm of the main piece into the cutout of the smaller piece,
and adjust it so that the base is at the appropriate height,
aligned with the base of the surrounding cabinet doors.
Use a screwdriver to tighten the panel alignment tool's
9.5 mm screw and hold it in place (step 3 in picture
above).
2. Attach the refrigerator door panel.
■ Peel the protective paper covers off of the adhesive pads
on each refrigerator door panel mount. There are two
adhesive pads on each of the four panel mounts.
■
At an angle, rest the base of the refrigerator door panel
on the panel alignment tool.
⁄₈" (1071.5 mm) x 23¼" (590 mm)