Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for SCORPION Sky Strider 280
Summary of Contents for SCORPION Sky Strider 280
- Page 1 Scorpion Sky Strider 280 Assembly Manual ...
- Page 2 Thank you for purchasing Scorpion Sky Strider 280 FPV racing frame. Please, prepare the following tools and materials before assembly. 3mm phillips 1.5mm hex 2mm hex Thread locker Parts UPPER FRAME ＊2 ALUMINIUM CROSS MEMBER ＊2 LOWER DECK ＊1 UPPER DECK＊1 FRONT FRAME MOUNT ＊1 TRANSMITTER BOARD ＊1...
- Page 3 There are two carbon fibre decks (upper and lower deck) inside the box. The upper deck is the one pre- assembled with nuts. Assemble the deck crossing member on the lower deck board with M2.5 *6 round screw at the appropriate position. As shown below:...
- Page 4 Insert the side straightener on both sideways and insert the front straightener at the front and rear straightener at the rear. Position the upper deck properly and tighten with M2.5 hexagon round screw. After placing the upper plate, tighten screws across other parts.
- Page 5 This section shows how to assemble the angled arm clamp. The picture below shows the two modules of the angled arm clamp, which are upper and lower. Position the upper and lower modules in between the decks using M2.5 *14 hexagon head to go through the frame and the clamp but do not tighten at this stage.
- Page 6 When installing the rear arm, please note that the direction of the holes near the frame is for undercarriage. The two holes should be parallel with the frame. The direction of the holes should be as shown in the picture.
- Page 7 This section shows how to assemble the camera damping system. Insert the damper in between the lens upper and lower board. Use M2 *4 Phillips’ head to fix the camera mounted on the L type arm. Then attach the other side to the damping plate(lens upper board) with the aid of M3 *6 flat head screws.
- Page 8 To assemble the upper frame, use M2.5 *6 hexagon round heads to cross between member frames. The member frame with holes is for the antenna tube and should be placed at the rear. Use M2 * 4 round Phillips’ screw, fixed to the frame, to mount between two frames.
- Page 9 To assemble the camera damping system on the upper frame. Use M2.5 *6 round hexagon screw in the front but do not tighten. Then, use the M2.5 *6 hexagon screw with cup washer screw in the adjustable track, now you can tighten the front screw when it is in the position as required.
- Page 10 Use M2.5 *6 to assemble the undercarriage under the motor arm. Then, heat up the antenna tube a little bit and bend it, after which you insert it into the rear cross member.
- Page 11 COMPLETE PICTURES ...
- Page 12 Thank you...
Need help?
Do you have a question about the Sky Strider 280 and is the answer not in the manual?
Questions and answers