WALL SETTING
• Please note that supplied wall setting
screws are used for wooden wall.
• Make sure that screws are firmly
secured to the wall (poll).
• Make sure that there is no electric
wiring or piping inside the wall.
Note
• Do not mount the dock connector on
plaster board, ALC (autoclaved
lightweight concrete), concrete block or
plywood less than 10mm thick as the
intensity is insufficient (If the dock
connector falls from the wall, it may
cause an injury).
1.
Disconnect the adapter.
2.
Remove the cover.
8
3.
Screws
4.
Adapter
5.
Cover
Notes
Install the supplied screws in the dock
connector and fasten it on the wall.
Wall
Attach the cover.
Wall
Connect the adapter
Adapter
Wall
• Be sure that the cover is attached or
removed in the direction of arrow shown
on the side.
• Do not leave the cover and adapter
removed while using the dock connector
as it may cause a malfunction.
Cover