Storing Blue Cord - Waterco Admiral Ultra Installation Operation User Manual

The following five points can prevent or greatly reduce the tangling of the blue power cord:
1) Make sure there are no objects in the pool during the cleaning cycle for the blue power cord to get caught on (pool ropes, toys, etc).
2) Only allow enough blue power cord in the pool for full coverage/do not put excess blue power cord in the pool
(Example 8m pool doesn't need 18m of blue power cord).
3) The Admiral Ultra should not be connected to a timing devise and left continuously within a Pool or Spa.
4) Remove the Admiral Ultra from the pool and uncoil the blue power cord from the power supply after ever cleaning cycle to release
the tension in the blue power cord.
5) The Admiral Ultra is designed to work with water at a temperatures > than 13ºC and < than 45ºC. The cleaner should never be operated
outside of these temperatures or damage may occur.
To uncoil the blue power cord, it is best that the cord is wet:
1. Place the cleaner on the ground as shown below.
2. Be sure to use a clear area that will allow the blue power cord to stretch out in a straight line.
3. Pull the blue power cord so it is off the ground.
4. Using your fingers, roll the blue power cord in the opposite direction that it is coiled in.
5. When straight, wrap blue power for storage as shown below in Fig 9.
StoRING tHE bLUE PoWER coRD
Loosely loop the blue power cord as shown in Figure 10.
n
Hold the blue power cord close to the cleaner.
n
Make a roughly half metre (two feet) loop with the blue power cord as shown.
n
When making loops, roll the blue power cord slightly in a counter clockwise manner
n
to maintain form.
Note: Do not wrap the blue power cord tightly around objects.
7
Figure 9
Figure 10