Installation - Waterco Admiral Ultra Installation Operation User Manual

INStaLLatIoN

Ensure power supply (transformer) is in the off position.
n
Plug the power transformer lead into its own dedicated 220-240V, 50Hz AC electrical outlet.
n
It is essential the power point is properly connected to an earth leakage circuit breaker and
properly earthed to ground. Consult a qualified electrician if you are unsure.
Do not plug the power supply lead into an extension cord.
n
Plug the floating blue power cord into the power transformer 25V connection socket.
n
Plug in the connector of the blue power cord from the cleaner into the power supply
n
(transformer). The connector is keyed so that it will only plug into the power supply
(transformer) one way. Make sure that the plug is pushed all the way onto the power supply (transformer).
Slide the connector lock (strain relief) onto the connector and turn the connector lock clockwise until it is tight (Do not over tighten).
WaRNING:
1. DO NOT RUN THE CLEANER OUT OF THE WATER. OPERATING THE CLEANER
OUT OF THE WATER WILL DAMAGE THE MOTORS AND VOID THE WARRANTY
2. THE ADMIRAL ULTRA SHOULD NOT BE CONNECTED TO A TIMING DEVICE
AND LEFT CONTINUOUSLY WITHIN A POOL OR SPA.
Place the Admiral Ultra into the pool and if needed rock the cleaner side to
n
side to release any trapped air. The cleaner will sink to the bottom of
the pool.
Place a sufficient length of the blue power cord into the water that will enable the Admiral Ultra to easily reach all areas of the pool.
n
(Do not place ALL of the blue power cord into the pool).
Turn on power supply at dedicated 220-240V, 50Hz AC electrical outlet and switch power
n
supply (transformer) to the on position, and the Admiral Ultra will begin its cleaning program.
The Admiral Ultra will automatically shut itself down after three hours.
n
If a second cleaning is required or the Admiral Ultra is accidentally shut off, you should wait
n
one minute before switching the cleaner on again. The cleaner has an automatic lock out
period to protect the electronic intelligent navigation devices.
IMPoRtaNt NotE:
During normal operation, the Admiral Ultra may appear to shut off for a few seconds. This is a
normal part of the pool cleaning program. The cleaner has multiple ways of cleaning the pool
walls. It may climb to the top of the pool wall, scrub, then make a turn and drive back down the
pool wall to the bottom of the pool. It may also climb to the top of the pool wall, shut down for a few seconds, remove itself from the pool wall,
turn its pump motor on again, pushing itself down to the bottom of the pool away from the wall.
The Admiral Ultra may also climb the pool wall, scrub to the waterline, turn the pump motor off, and float away from the pool wall down to the
bottom of the pool. All of these variations have been programmed into the cleaner and are designed to quickly and efficiently clean your
entire pool.
The Admiral Ultra has also been designed to clean all areas of your pool. It will climb the pool walls, and occasionally break the pool water
surface. In the process of climbing the pool walls it may stay on the pool water surface and continue to operate from several seconds to a
few minutes. This is a normal operation procedure and the cleaner will eventually make its way to the bottom of the pool to continue its
cleaning program. Generally, most of the dirt is concentrated on the floor of a pool the cleaner will spend the majority of cleaning program on
the pool floor.
4