Waterco Admiral Ultra Installation Operation User Manual

Robotic pool scrubber cleaner

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

RobotIc PooL ScRUbbER cLEaNER

Installation - operation - Warranty Manual

This equipment is to be installed and serviced by a qualified technician. Improper installation may result in

property damage, serious injury or death. Improper installation and/or operation will void the warranty.

WaRNING

Notice to Installer

This manual contains important information about the installation, operation & safe use of this product.

Once the product has been sold or installed this manual must be given to the owner/operator of this equipmen

www.waterco.com

Table of Contents

Summary of Contents for Waterco Admiral Ultra

Page 1 Improper installation and/or operation will void the warranty. WaRNING Notice to Installer This manual contains important information about the installation, operation & safe use of this product. Once the product has been sold or installed this manual must be given to the owner/operator of this equipmen www.waterco.com...
Page 2: Table Of Contents
Robotic Pool Cleaner available. We are sure you will find your new Admiral Ultra a pleasure to use. Before you use the cleaner, we recommend that you read through the relevant sections of this manual, which provides a description of your cleaner and its functions.
Page 3: General Instructions
Do not store pool chemicals near your equipment. 10. Do not play with the Admiral Ultra or blue power cable as potential entrapment of hair or body parts may result. The blue power cord can trip or entangle swimmers which could result in drowning.
Page 4: Installation
The Admiral Ultra may also climb the pool wall, scrub to the waterline, turn the pump motor off, and float away from the pool wall down to the bottom of the pool.
Page 5: Removing Cleaner From Pool
Grip the bottom lid of the Admiral Ultra firmly, with one hand and use your other hand to grab the filter bag material and pull it away from and up from the bottom lid of the cleaner. Remove all large debris from the filter bag. Refer Figure 4.
Page 6: Blue Cord Maintenance
Once the Admiral Ultra’s bottom lid is seated press it firmly into the cleaner. Gently pull on the cleaner bottom lid to insure that it is properly locked in.
Page 7: Storing Blue Cord
5) The Admiral Ultra is designed to work with water at a temperatures > than 13ºC and < than 45ºC. The cleaner should never be operated outside of these temperatures or damage may occur.
Page 8: General Maintenance
The warranty obligations of Waterco Ltd shall be limited to repair or replacement of the product or any defective component, at the discretion of Waterco Ltd. The repair or replacement may include the use of refurbished components and/or units. Waterco Ltd will not be liable or responsible under any circumstances or in any amount for any consequential or incidental damages, for any injury or damages to persons or property using or used in connection with this product, or for loss of profits or other costs or expenses of any kind or character.
Page 9 WaRRaNtY coVER If a defect occurs in any Waterco product, Waterco will at its discretion, repair the product or replace and install the defective part, free of charge provided that the defect results solely from poor workmanship or materials and subject to these terms and conditions.
Page 10 To the extent permitted by law Waterco excludes all liability it may have to the purchaser for indirect, special or consequential loss arising from or related to any defect in any Waterco product, or any act or omission of Waterco, including, but not limited to, loss of business, loss of profit, loss of revenue, lost opportunity, inconvenience, and damage to any property other than the Waterco product.
Page 11 Most pool cleaner problems are caused by incorrect installation, poor water chemistry and wear and tear. Please regularly check the condition of the Admiral Ultra filter bag, bottom lid, brushes and tracks, as these are like the tyres on a car & need replacement from time to time.
Page 12: Trouble Shooting
Symptom Possible Reasons cleaner Dead in water/Will not Restart Is time being allowed for the unit to reset? At least 30 second are needed between cycles to reset the power supply. Is the outlet working? Earth Leakage Circuit Breaker or breaker may have tripped Is an extension cord being used? Extension cord may be defective cleaner not Moving...
Page 13 Potential Solution Turn power supply off and allow 30 seconds for cleaner to reset. Check Earth Leakage Circuit Breaker or breaker and try a different outlet. Try running the cleaner without an extension cord. Using a Electrical Extension cord is not recommended. Check for debris and remove if found.
Page 14: Notes
NotES...
Page 15 NotES...
Page 16 3 Rue Paul Rieupeyroux #05-02/04 Nehsons Building Canada J2R 1T8 Kent, ME9 9PS, UK 69800 SAINT PRIEST Singapore 079314 tel: + 450 796 1421 tel: + 44 1795 521733 France tel: + 65 6344 2378 tel: +33 (0)4 72 79 33 30 www.waterco.com...