Advertisement
C O N V E N I E N C E
KEYLESS TRANSMITTER ICONS*
To unlock and open the door, pull the
front exterior door handle. The unlock
• Press
once to lock all doors.
sensor is on the back of the handle.
Press again within three seconds
Make sure not to touch the lock sensor
to confirm all doors are locked.
area on the front of the handle.
• Press
once to unlock the driver's
To lock the doors, press and hold the
door. Press again within three
door handle lock sensor for about a
seconds to unlock all doors.
second. To avoid unlocking the door
• Press
to start the panic alarm.
inadvertently, make sure you only touch
Press again or switch on the ignition
the lock sensor and not other areas of
to stop the alarm.
the door handle.
• Press
twice within three
To unlock and open the liftgate, press
seconds to open the liftgate.
the exterior release button on top of
• Car finder: Press
twice within
the liftgate pull-cup handle.
three seconds to locate your
See your Owner's Manual for more
vehicle. The horn sounds and
information.
the direction indicators flash.
REMOTE START*
INTELLIGENT ACCESS*
Remote start allows you to start the
engine from outside your vehicle using
NOTE:
Your intelligent access
your key. To start, press
transmitter must be within 3 feet
press
twice within three seconds.
(1 meter) of the vehicle for intelligent
Your vehicle will run for 5, 10 or 15
access to function properly.
minutes, depending on the setting.
See the Information Displays chapter
in your Owner's Manual to select the
duration of the remote start system.
Once inside, switch the ignition on as
you normally would before driving. To
switch the engine off from outside the
vehicle after using your remote start,
press
once.
16
REMOTE CONTROL FEEDBACK
An LED on your transmitter provides
visual feedback from your remote start
or stop commands:
Solid Green: Remote start successful.
The light remains on for a short time
and then goes out.
Solid Red: Remote stop successful,
vehicle off. The light remains on for a
short time and then goes out.
Blinking Red: Remote start or stop
failed. The light blinks a few times and
then stops.
Blinking Green: Waiting for status
update. The light blinks a few times
and then stops.
110-VOLT AC POWER POINT*
The power point
is on the rear
and then
of the center
console and
can be used
to power your
smaller electrical
devices that do
not exceed 150
watts. You can use this feature after
you switch your ignition on and the
battery voltage is above 11 volts. When
the indicator light is on, the power point
is working and ready to use.
*if equipped
POWER LIFTGATE*
HANDS-FREE LIFTGATE OPERATION*
Your liftgate has an automatic
To Open Your Liftgate Hands-Free While You Are at the Liftgate
open and closing feature. To
1. Make sure you have an intelligent access transmitter*
open remotely, press
twice
within 3 feet (1 meter) behind the liftgate.
on your transmitter within
2. Move your foot under and away from the rear bumper
three seconds. Press
twice
using a single kicking motion. Do not move your foot
again to close or reverse the
sideways or the sensors may not detect the motion.
movement. To use the power
feature from the driver seat,
DUAL-PANEL MOONROOF AND POWER SUNSCREEN*
press the
control located
on the instrument panel.
Use the one-touch, express-opening and express-closing feature to
control various functions. To open, press and release the SLIDE
You can also program a new
control. The sunscreen opens automatically and the moonroof
liftgate height by opening the
opens to the first position. To open the moonroof fully, press and
liftgate, adjusting the liftgate
release the SLIDE control again. To close, pull and release the
manually to your desired height
SLIDE control. Press and release the TILT control to vent the
and then pressing and holding
moonroof. Pull and release the TILT control to close the moonroof.
the liftgate control button. The
To open the sunscreen, press and release
system sounds a tone once it
to close the sunscreen.
saves the new liftgate height.
AUTO-FOLDING EXTERIOR MIRRORS*
This feature automatically folds the exterior mirrors toward the
glass after you place the transmission into park (P), switch off
the vehicle, open and close the driver door and lock the vehicle.
The exterior mirrors automatically unfold and return to the driving
position after you unlock the vehicle and open and close the driver
door. Additionally, you can use the control on the door to fold the
mirrors on-demand.
Note:
If you use the power-fold control to fold the mirrors
on-demand and the auto-fold feature is switched on, you must
use the control again to unfold them. See the Windows and Mirrors
chapter in your Owner's Manual for complete details.
*if equipped
. Pull and release
17
*if equipped
Advertisement
