Vivid Audio GIYA Owner's Manual page 7

should read "the crate should be positioned on the
STEP 1
floor resting on its pallet feet as shown. remove
the ten 10mm lid securing bolts. set aside for use
when replacing the lid. remove the (heAVy) lid
CAreFuLLy, setting aside for use later. remove
the skids, the accessory kit and the two grille boxes.
then remove the two upper packaging inserts (Foam
rubber and polystyrene). there is also a separate
foam rubber protector for the bass driver. this must
be removed carefully.
Carefully tilt the entire crate, (skids and cabinet
STEP 3
inside) onto its end so that the skids are flat against
the ground. Be sure that the speaker does not fall out
as the crate approaches the vertical. Grab hold of
the two handles in the base board and slowly pull the
loudspeaker out of the crate. Pull it to the edge of the
skids but not off them. only pull on the base board,
not on the cabinet. this will keep the speaker stable
as you pull it out.
uN PA C KI NG sequen ce
Position the skids as shown below. there are slots
STEP 2
machined above the base board bolted onto the
bottom of the loudspeaker - the skids are fitted into
these.
tilt the speaker, and lift it off the skids, laying it down
STEP 4
on a soft, clean surface. there are six m8 bolts holding
the base board to the cabinet. you should be able to
loosen them using fingers only. If you cannot, a size
13 spanner (metric) or a shifting spanner will loosen
the bolts. remove them and then lift the speaker off
of the base board. you can use the port apertures or
the spiral to lift the cabinet. With care, the speaker
can also be lifted using fingers in the groove near the
bass drivers. there is a handle moulded into the base
of the speaker as well.
ChAPter 2 5