Vivid Audio GIYA Owner's Manual page 6

should read "the crate should be
STEP 1
positioned on the floor resting on
its pallet feet as shown. remove
the ten 10mm lid securing bolts.
set aside for use when replacing
the lid. remove the (heAVy) lid
CAreFuLLy, setting aside for use
later.
Carefully tilt the entire crate, (skids and cabinet
STEP 3
inside) onto its end so that the skids are flat against
the ground. Be sure that the speaker does not fall out
as the crate approaches the vertical. Grab hold of
the two handles in the base board and slowly pull the
loudspeaker out of the crate. Pull it to the edge of the
skids but not off them. only pull on the base board,
not on the cabinet. this will keep the speaker stable
as you pull it out.
uN PA C KI NG
remove the skids, the accessory
STEP 2
kit and the two grille boxes.
then remove the two upper
packaging inserts (Foam rubber
and polystyrene). there is also a
separate foam rubber protector
for the bass driver. this must be
removed carefully.
sequen ce
STEP 3
tilt the speaker, and lift it off the skids, laying it down
STEP 4
on a soft, clean surface. there are six m8 bolts holding
the base board to the cabinet. you should be able to
loosen them using fingers only. If you cannot, a size
13 spanner (metric) or a shifting spanner will loosen
the bolts. remove them and then lift the speaker off
of the base board. you can use the port apertures or
the spiral to lift the cabinet. With care, the speaker
can also be lifted using fingers in the groove near the
bass drivers. there is a handle moulded into the base
of the speaker as well.
Position the skids as shown below.
there are slots machined above
the base board bolted onto the
bottom of the loudspeaker - the
skids are fitted into these.
CHAPTER 2 4