BMW F 800 GT Rider's Manual page 53

Activation with motion
sensor
The alarm function is activated
by pressing button 1 on the
remote control once, or
by switching off the ignition (if
programmed); when the igni-
tion is switched off 30 seconds
elapse before the start of the
activation phase
Activation is confirmed
by the turn indicators flashing
twice and
by the alarm tone sounding
twice.
If you want to activate the alarm
function more than one minute
after switching off the ignition,
you must press button 1 for
longer than one second. If it is
not armed within approximately
one hour, the DWA anti-theft
alarm shuts down in order not to
draw power unnecessarily from
the battery. If you want to activ-
ate the alarm function after the
anti-theft alarm has shut down in
this way, you have to switch the
ignition on and then off again.
Activation phase
The anti-theft alarm needs 15
seconds to achieve fully active
status. No alarm is triggered dur-
ing this time.
Conserving battery power
If you want to activate the alarm
function more than one minute
after switching off the ignition,
you must press button 1 for
longer than one second. If it
remains deactivated for approx-
imately one hour, the anti-theft
alarm shuts down in order not to
draw power unnecessarily from
the battery. If you want to activ-
ate the alarm function after the
anti-theft alarm has shut down in
this way, you have to switch the
ignition on and then off again.
5
51
z