Normal Record Setting Menu Alarm Record Setting Menu Buzzer Setting Menu Archive Setting Menu Network Setting Menu System Setting Menu These Installation and Operating Instructions, (edition 03/2003, Ver 1.3) are for use with One channel digital video recorder (year 2003 model) ZR-DH111NP...
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: • Operation status record log (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. ZR-DH111NP...
LCD display, and press to change the speed if necessary. 10 Hard Disk Tray and Compact Flash Card Slot Hard Disk holder for HDD and Insert a Compact Flash Card. 5 REC Press this key to start recording. ZR-DH111NP...
Page 6
Press this key to enter the Search Playback system. Menu. 19 Remote Control 13 COPY IR Remote receiver Press this key to start copy still picture or video stream into Compact Flash card. 14 Display Press this key to switch ON/OFF the display. ZR-DH111NP...
4. NORMAL RECORD SETTING MENU 5. ALARM RECORD SETTING MENU 6. BUZZER SETTING MENU 7. ARCHIVE SETTING MENU 8. NETWORK SETTING MENU 9. SYSTEM SETTING MENU 5 Turn the shutter dial clockwise or counterclockwise to change set up page. ZR-DH111NP...
These two audio outputs can be set enable or disable in Setup Menu. The S-VIDEO output connector. 5 MUX MAIN MONITOR 10 VIDEO OUT(1) Video input BNC connector, connected to multi- The composite video output connector. plexer main monitor output. ZR-DH111NP...
Page 9
REC signal drops from High to Low level. 14 Alarm Output Terminal Block ALM-NC Normal Close Alarm output. In normal condition, this terminal is shorted to the terminal of ALM- COM. In alarm status, it is open between ALM-NC and ALM-COM terminals. ZR-DH111NP...
4 Please set the Multiplexer item to OFF . 5 System Main Monitor Out (NORMAL RECORD SETTING MENU) Connect the MAIN MONITOR OUTPUT connec- tor to the main monitor. 6 Please set the Multiplexer item to ON . (NORMAL RECORD SETTING MENU) ZR-DH111NP...
Connected to the MUX. Main connector at the rear panel. 4 System Main Monitor Output: Connect the MAIN MONITOR OUTPUT connec- tor to the main monitor. 5 Please set the Multiplexer item to ON . (NORMAL RECORD SETTING MENU) ZR-DH111NP...
8 MENU BACKGROUND Black out video ON/OFF when in Menu Mode : Press LEFT or RIGHT to move the cursor to the left or right. LEFT RIGHT : Press UP or DOWN or Jog Dial to change the value. DOWN ZR-DH111NP...
Set “OFF” when not using timer recording. 7 DLY Record on same schedule every day. : Press LEFT or RIGHT to move the cursor to the left or right. LEFT RIGHT : Press UP or DOWN or Jog Dial to change the value. DOWN ZR-DH111NP...
: Press UP or DOWN or Jog Dial to change the value. DOWN The main monitor output is same as video out connector all the time. 4 RECORD MODE There are two record modes for Time lapse re- cording. FIELD or FRAME 5 Disk Full STOP ZR-DH111NP...
If the alarm occurs when it is in timer recording mode, the recording quality will be the same as 7 PRE–ALARM OPERATION the value set in timer recording quality. Record the picture in pre-alarm recording speed in pre-alarm period. No pre-alarm recording before alarm occurs. ZR-DH111NP...
: Press UP or DOWN or Jog Dial : Press UP or DOWN or Jog Dial to change the value. DOWN to change the value. DOWN 6 MULTIPLEXER In order to view each channel of multiplexer from LAN, please select DPLEX16-ECO among list. ZR-DH111NP...
: Press LEFT or RIGHT to move the cursor to the left or right. LEFT RIGHT : Press UP or DOWN or Jog Dial to change the value. DOWN Therefore, be sure to make a note of the password. ZR-DH111NP...
Page 18
YES The confirmation dialog will appear on the screen. DISK RENEW Press ENTER key to NOT renew HDD and Exit. If not, press RIGHT key to move the cursor to YES, and then press DISK RENEW ENTER key to Renew HDD. ZR-DH111NP...
Page 19
10 PLAY MODE The play mode can be FIELD or FRAME. : Press LEFT or RIGHT to move the cursor to the left or right. LEFT RIGHT : Press UP or DOWN or Jog Dial to change the value. DOWN ZR-DH111NP...
Notice The recording quality in pre-alarm duration is the same as recording quality before alarm occurs. If the recorder is not recording before alarm occurs, the recording quality in pre-alarm duration will be the same as instant recording quality. ZR-DH111NP...
Turn the jog dial counterclockwise to rewind the reverse playback starts. still image Frame/Field by Frame/Field. The speed will be shown on the LCD. The Frame/Field feed speed will increase if the jog << 2, 4, 6, 8, 16, 32, 600X dial is turned quickly. ZR-DH111NP...
Press enter and the playback starts from the date/time set in the menu. YEAR/MM/DD HH:MM:SS 2002 04 24 19 03 35 Notice: If there is no image stored in the date/time specified then the machine will start playing back from the nearest set time automatically. ZR-DH111NP...
Press STOP key to end play. Notice: Copied images are stored as a movie picture. Copied files are saved as .MOV file. Use QuickTime to play the retrieved .MOV files. You may download QuickTime at www.apple.com. The playback version for QuickTime is free. ZR-DH111NP...
PIN # NAME NOT CONNECTED NOT CONNECTED NOT CONNECTED GROUND GROUND NOT CONNECTED NOT CONNECTED NOT CONNECTED NOT CONNECTED Transmission setting The transmission setting is 9600 baud rate, 8 data bits, 1 start bit, 1 stop bit and no parity. ZR-DH111NP...
The effective PAUSE SEARCH COPY DISPLAY distance is up to 10 meters without any obstacle. The keypad functions are as same as the front panel of the one channel digital video recorder. Figure 1 ZR-DH111NP...
The “one channel digital video recorder Login” page will show on the screen. User must enter the correct user-name and password defined in the Network Setting Menu. For example: Enter ADMIN for use name and ADMIN for password and then Click on “submit” to enter to system. ZR-DH111NP...
PAUSE : Press this key to pause the Video display. Control Mode: This key will switch user to direct remote control mode. Note: Control Mode which only allow use with access level “Super” use. 8 Control for Playback Video Speed 9 Control for Playback Position ZR-DH111NP...
Page 30
15 Quad screen view 16 Nine split screen view 17 Sixteen split screen view 18 A pop-up menu to select camera to view will be shown by pressing right mouse button. ∗ 15, 16, 17, 18 functions are available with limited MUX. ZR-DH111NP...
• Provide date time search • Three user level support. • Three user accounts for login. • 1/4/9/16 split windows for multiplexer display. (DM, ROBOT, ATV) • No need to install additional application software. Just use standard browser with JAVA support. Internet/Intranet ZR-DH111NP...
On screen display setup User Interface Menu Driven User Input Device Front Panel Keypad Timer Built-in real time clock Water Mark Weight 5.2kg Power Source AC100-240V Dimension 430mm(L) × 88mm(W) × 300mm(H) Operating Temperature 0°C∼+50°C Tokyo, Japan www.GANZ.jp MSR1G 01510 ZR-DH111NP...