Assembly; Install Handle (Fig. 2) - Toro 22045 Operator's Manual

Turn key in ignition
switch.
Move control.
Move control forward.
Move control
rearward.

Assembly

Install Handle (Fig. 2)

1. Mount handle to outside of mower housing, using
bottom hole, with (2) 5/16–18 x 1–1/4" (8 mm x 31
mm) capscrews, washers, and thin nylon insert
locknuts (Fig. 2).
2. Secure handle latches to handle with (2) 5/16–18 x
1–1/2" (8 mm x 38 mm) capscrews, washers and nylon
insert locknuts (Fig. 2).
Note: Handle height is adjustable for operator comfort.
Stand behind mower handle to gauge height. To adjust
handle height, reposition capscrews and locknuts securing
handle latches to handle into other mounting holes in
latches.
3. Slide bag support rod thru top mounting holes in
handle and secure each end with a cap locknut (Fig. 2).
Raise/lower control
bar.
Raise/lower control
bar.
Raise control bar.
Raise control bar.
Lower control bar.
1. Handle
2. Cap locknut
4. Use cable ties to secure the control cables to handles
below the bag support rod.
7
m-534
Figure 2
3. Bag support rod
4. Handle latch