Table of Contents
Advertisement
If the bag is on the mower, remove it and insert the
mulch plug (refer to Removing the Grass Bag) before
side-discharging the clippings.
Important: The mower has a safety switch that
prevents you from starting the mower unless you
first install the mulch plug securely on the mower
(refer to Mulching the Clippings).
Installing the Side Discharge Chute
1. Unlock the side discharge door (Figure 27).
2. Lift open the side discharge door (Figure 28).
3. Install the side discharge chute and close the door
onto the chute (Figure 29).
Removing the Side Discharge Chute
To remove the side discharge chute, reverse the steps
above.
Figure 27
Figure 28
Figure 29
Important: Lock the side discharge door after you
close it (Figure 30).
Operating Tips
General Mowing Tips
• Clear the area of sticks, stones, wire, branches, and
other debris that the blade could hit.
• Avoid striking solid objects with the blade. Never
deliberately mow over any object.
• If the mower strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire
from the spark plug, and examine the mower for
damage.
• For best performance, install a new blade before the
cutting season begins.
• Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
• Cut only about a third of the grass blade at a time.
Do not cut below the 2 inch (51 mm) setting unless
the grass is sparse or it is late fall when grass growth
begins to slow down. Refer to Adjusting the Cutting
Height.
• When cutting grass over 6 inches (15 cm) tall, mow
at the highest cutting height setting and walk slower;
then mow again at a lower setting for the best lawn
appearance. If the grass is too long, the mower may
plug and cause the engine to stall.
• Mow only dry grass or leaves. Wet grass and leaves
tend to clump on the yard and can cause the mower
to plug or the engine to stall.
WARNING
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Mow only in dry
conditions.
13
Figure 30
Advertisement
Table of Contents
