Table of Contents
Advertisement
totally surround the mower by uncut grass. Always try to
have one side of the mower free from uncut grass, which
allows air to be drawn into the mower.
Using the Mower for the First Time
Cut grass slightly longer than normal to ensure the cutting
height of the mower does not scalp any uneven ground.
However, the cutting height used in the past is generally
the best one to use. When cutting grass longer than six
inches tall, you may want to cut the lawn twice to ensure a
quality cut.
Cut 1/3 of the Grass Blade
It is best to cut only about 1/3 of the grass blade. Cutting
more than that is not recommended, unless grass is sparse
or it is late fall when grass grows more slowly.
Mowing Direction
Alternate mowing direction to keep the grass standing
straight. This also helps disperse clippings which enhances
decomposition and fertilization. Avoid mowing in
reverse.
Mow at Correct Intervals
Normally, mow every 4 days. But remember, grass grows
at different rates at different times. So to maintain the
same cutting height, which is a good practice, mow more
often in early spring. As the grass growth rate slows in
mid summer, mow less frequently. If you cannot mow for
an extended period, first mow at a high cutting height;
then mow again 2 days later at a lower height setting.
Ground Speed
To improve cut quality, use slower ground speed. For best
operation on average lawns, operate engine at full throttle
while controlling ground speed with transmission. The
tractor should be operated at 2 to 3.5 mph (3.2 to 5.6
kms/hr) while mowing grass. Uneven cutting is often a
Maintenance
Service Interval Chart
Service Operation
Blade—check
Mower Spindles—grease
Center Idler and Rear Wheels—grease
result of excessive ground speed. To correct, use low
range with the high-low lever, or reduce ground speed in
high range.
Avoid Cutting Too Low
If the cutting width of the mower is wider than the mower
you previously used, raise the cutting height to ensure
uneven turf is not cut too short. Average lawns are
usually cut at a height between 2 and 3 inches (5–7.6 cm).
Long Grass
If the grass is ever allowed to grow slightly longer than
normal, or if it contains a high degree of moisture, raise
the cutting height higher than usual and cut the grass at
this setting. Then cut the grass again using the lower,
normal setting.
When Stopping
If the machine's forward motion must be stopped while
mowing, a clump of grass clippings may drop onto your
lawn. To avoid this, perform the following procedure:
1. With the blades engaged, move onto a previously cut
area.
2. To disperse the clippings evenly, raise the mower
while driving forward with the blades engaged.
Keep the Underside of the Mower Clean
Clean clippings and dirt from the underside of the mower
after each use. If grass and dirt build up inside the mower,
cutting quality will eventually become unsatisfactory.
Blade Maintenance
Maintain a sharp blade throughout the cutting season
because a sharp blade cuts cleanly without tearing or
shredding the grass blades. Tearing and shredding turns
grass brown at the edges, which slows growth and
increases the chance of disease. Every 30 days, check the
blades for sharpness and file down any nicks.
Each
5
25
Use
Hours
Hours
X
X
X
X
16
50
Storage
Hours
Service
X
X
X
Spring
Service
Advertisement
Table of Contents
