Cutting Blade - Toro 78395 Operator's Manual

Service Operation
Belts—check for wear/cracks
Mower Housing—clean
Belt Tension—check
Chipped Surfaces—paint
POTENTIAL HAZARD
If you leave the key in the ignition switch, someone could start the engine.
WHAT CAN HAPPEN
Accidental starting of the engine could seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
Remove the key from the ignition switch and pull the wire(s) off the spark plug(s) before you
do any maintenance. Also push the wire(s) aside so it does not accidentally contact the spark
plug(s).

Cutting Blade

For a superior quality of cut, keep the blade(s) sharp. For
convenient sharpening and replacement, you may want to
have an extra blade(s).
POTENTIAL HAZARD
A blade that is worn or damaged could break
apart and pieces could be thrown at bystanders
or at you as you use the mower.
WHAT CAN HAPPEN
Pieces of blade that may be thrown could
seriously injure or kill you or bystanders.
HOW TO AVOID THE HAZARD
Periodically inspect the blade for wear and
damage. Immediately install a new blade if it is
worn or damaged.
Inspecting the Blades
1. Remove the mower; refer to Removing the Mower,
page 11.
2. Inspect the cutting edges (Fig. 32). If the edges are not
sharp or have nicks, remove the blade(s) and sharpen
them; refer to Sharpening the Blade(s), page 18.
3. Inspect the blade(s), especially the curved area (Fig.
32). If you notice any damage, wear, or a slot forming
in this area (Fig. 32), immediately install a new blade.
Each 5 25
Use Hours Hours
X X
initial
1. Cutting edge
2. Curved area
Removing the Blade
1. Remove the mower; refer to Removing the Mower,
page 11.
2. Carefully tip the mower over.
3. Hold the blade end using a rag or thickly padded
glove.
4. Remove the bolt, washer, blade, spindle cup, and
washer (Fig. 33).
Note: A block of wood may be wedged between the blade
and the mower to lock the blade when you are removing
the bolt.
17
50 Storage
Hours Service
X
X
X X
X
2
Figure 32
3. Wear/slot forming
Spring
Service
1
3
151