Toro 23210 Operator's Manual page 39

10. Place a rag over the spark plug hole to catch any oil
spray, then use the starter or recoil handle to crank
the engine and distribute the oil inside the cylinder.
11. Install the spark plug, but do not install the wire on
the spark plug.
12. Charge the battery; refer to
Servicing the Battery (page 28).
13. Check and adjust the track tension; refer to
Checking and Adjusting the Track Tension (page 30).
14. Check and tighten all bolts, nuts, and screws. Repair
or replace any part that is damaged.
15. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
16. Store the machine in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it in a memorable place.
17. Cover the machine to protect it and keep it clean.
39