Toro 23210 Operator's Manual page 34

1. Traction control
5. Adjust the traction control so that it rests flush
against the reference bar when it is pulled straight
back (Figure 51 and Figure 52).
6. Tighten the flange nut and bolt in the traction
control stem.
7. Start the engine.
8. Drive the machine in reverse with the traction
control tight to the reference bar. If the machine
does not back up straight, complete the following
procedure:
A. Stop the engine
B. Lift/support the machine so that both tracks are
off of the ground and are free to run.
C. Loosen the flange nut and bolt in the stem of the
traction control (Figure 51).
D. Loosen the jam nuts on the traction rods, under
the control panel (Figure 53).
Figure 51
2. Stem , bolt and nut
Figure 52
1. Traction rod
E. Start the machine and set the throttle to about
1/3 open position.
WARNING
When the machine is running, you could
be caught and injured in moving parts or
burned on hot surfaces.
Stay away from pinch points, moving parts,
and hot surfaces when adjusting the running
machine.
F. Have a helper hold the traction control tight to
the reference bar in reverse.
G. Adjust the length of the traction rods until both
tracks are running at the same speed.
Note: You can also adjust the maximum reverse
speed of the tracks at this time.
H. Tighten the jam nuts.
I. Adjust the traction control so that it rests flush
against the reference bar when it is pulled straight
back (Figure 51 and Figure 52).
J. Tighten the flange nut and bolt in the traction
control stem.
K. Stop the engine and lower the machine to the
ground.
L. Drive the machine in full reverse, checking to
see if the unit tracks straight. If it does not,
note the direction the machine veers. Repeat the
adjustment previously described so that it tracks
straight in reverse.
34
1
2
1
2
Figure 53
2. Jam nut
G011476