Bagging The Clippings - Toro 22295 Operator's Manual

1. Rear-discharge plug
WARNING
Operating the machine to recycle lawn clippings
without the plug in place allows objects to be
thrown in your direction or in the direction of
bystanders. Also, contact with the blades could
occur. Thrown objects or blade contact can cause
serious injury or death.
Ensure that the rear-discharge plug is in place
before you recycle the clippings. Never engage the
blades without either the rear-discharge plug or the
grass bag installed on the machine.

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown toward you or
bystanders, resulting in serious personal injury or
death.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
WARNING
The blades are sharp; contacting the blades can
result in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Raise and hold up the rear door
Figure 19
2. Rear door
(Figure 20).
1. Rear door
2. Bag-rod end (2)
3. Remove the rear-discharge plug by pushing in the latch
with your thumb and pulling the plug out from the
machine (Figure
4. Install the bag-rod ends into the notches at the base of
the handle, and rock the bag back and forth to ensure
that the bag-rod ends are seated at the bottom of both
notches (Figure
5. Lower the rear door until it rests on the grass bag.
Removing the Grass Bag
DANGER
The machine can throw grass clippings and other
objects through an opening in the mower housing.
Objects thrown with enough force could cause
serious personal injury or death to you or to
bystanders.
• Never remove the grass bag and then start the
engine without the discharge plug installed on
the machine.
• Never open the rear door on the machine when
the engine is running.
1. Stop the engine and wait for all moving parts to stop.
2. Raise the rear door.
3. Remove the bag rod on the grass bag from the notches
at the base of the handle
4. Install the discharge plug; refer to
Clippings (page
5. Lower the rear door.
14
Figure 20
3. Notch (2)
19).
20).
(Figure 20).
Recycling the
13).