Installing The Wheels; Installing The Steering Wheel - Toro 12004TC Operator's Manual

1

Installing the Wheels

Parts needed for this procedure:
4 Wheel assembly
Procedure
1. Remove the fasteners securing the wheels.
2. Remove the shipping bracket secured to the wheel
studs.
3. Mount the wheels with the previously removed
fasteners (Figure 3) and torque to 45-65 ft-lb
(61-88 N-m).
1. Wheel assembly
2. Wheel nut
Figure 3
3. Wheel stud (rear wheel
hub shown)
2

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
Procedure
1. Remove the nut and washer from the steering shaft.
2. Slide the steering wheel and washer onto the shaft.
Position the steering wheel on the shaft so that the
cross beam is horizontal when the tires are pointed
straight ahead and the thicker spoke of the steering
wheel is downward.
3. Secure the steering wheel to the shaft with the nut
(Figure 4). Torque the nut to 18-22 ft-lb (24-29 N-m)
1. Steering wheel
2. Nut
11
Figure 4
3. Washer
4. Foam seal