Stopping The Machine; Positioning The Seat; Hairpin Cotter - Toro 74182 Operator's Manual

Operation

Stopping the Machine

To stop the machine, move the motion control levers
to neutral, disengage the power take off (PTO), and
turn the ignition key to "OFF" to stop the engine.
Also set the parking brake when you leave the
machine; refer to Setting the Parking Brake, page 13.
Remember to remove the key from the ignition
switch.
POTENTIAL HAZARD
Someone could move or attempt to operate
the tractor while it is unattended.
WHAT CAN HAPPEN
Children or bystanders may be injured if
they use the tractor.
HOW TO AVOID THE HAZARD
Always remove the ignition key and set the
parking brake when leaving the machine,
even if just for a few minutes.
18

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1. To adjust, remove hairpin cotter and washer,
holding seat base down, and tip seat forward
(Fig. 10).
1
2
3
Figure 10

1. Hairpin cotter

2. Washer
2. Loosen the seat mounting bolts slide seat to the
desired position in the adjusting slots and tighten
the mounting bolts (Fig. 11).
3. Lower seat and secure with washer and hairpin
cotter (Fig. 10).
2
Figure 11
1. Adjustment slot
2. Mounting bolt
m–3728
3. Seat base
1
m–3280
1200