Deactivation - BMW F 800 GS Adventure Rider's Manual

Reason for triggering of
the alarm
After the alarm function has been
deactivated, the DWA indicator
light signals the reason for any
alarm triggering which may have
occurred for one minute:
1x flash: motion sensor; motor-
cycle was tilted forward/back
2 flashes: motion sensor; mo-
torcycle was tilted to the side
3 flashes: ignition switched on
with unauthorized key
4 flashes: DWA disconnected
from motorcycle battery
Note on alarm triggering
If an alarm was triggered after
the last activation of the alarm
function, then this is pointed out
with a single signal tone after the
ignition is switched on.

Deactivation

with anti-theft alarm system
OE
(DWA)
Deactivate alarm function
Press button 2 of remote con-
trol once or switch on ignition
with an authorized key.
The alarm function can only
be deactivated with the ig-
nition key if the emergency ON/
OFF switch is in the operating
position.
If the alarm function is de-
activated by means of the
remote control and the ignition
then not switched on, the alarm
function is automatically reacti-
vated after 30 seconds if "Acti-
vation after ignition off" has been
programmed.
Turn indicators light up once.
Alarm tone sounds once (if
programmed).
Alarm function is deactivated.
Protection of the battery
After approx. one hour in the
activated state, the receiver
for the remote control in the
DWA switches off to protect the
battery. The ignition must be
switched on to deactivate the
alarm function after this period.
5
57
z