Windows 8; Windows 7 Setup; Additional Information - Mad Catz L.Y.N.X. 3 Product Manual

Windows 8

1. On your host device, reveal the sidebar and navigate to Settings>Change PC Settings>PC and
devices>Bluetooth. Be sure to enable Bluetooth on the computer.
2. Press and hold the controller home button for 3 seconds to power it on. The status LED will flash red
to blue.
3. Windows will automatically search for available devices.
4. Mad Catz L.Y.N.X.3 will appear in in the list of devices. Tap/click the entry to pair.
5. When pairing is complete the device list will indicate the product is connected. The LED on the pad
will also be pulsing blue.

Windows 7 Setup

1. On your host device, click the Start button and open Devices and Printers. Click the 'Add Device'
option.
2. Press and hold the controller home button for 3 seconds to power it on. The status LED will flash red
to blue.
3. Windows 7 will automatically search for available devices.
4. Mad Catz L.Y.N.X.3 will appear in the list of devices. Click the entry and then click NEXT to pair.
5. When pairing is complete the device list will indicate the product is connected. The LED on the pad
will also be pulsing blue.

Additional Information

 The
3 can store two paired devices in memory. This means you could have the pad paired to
L.Y.N.X.
your M.O.J.O. or home computer, and also a phone or tablet for on-the-go gaming
o Once you are paired to your first device, power down Bluetooth on the host
o The controller LED will flash red to blue to indicate it is ready to pair
o Initiate pairing on the second device
o You can then easily swap connections between both devices by managing the Bluetooth
status on each of the hosts.
o Turn Bluetooth off on the second device. On the first host, turn Bluetooth on. Press the home
button on L.Y.N.X. and it will then reconnect to the first host. Reverse this process to go back
to the other host.
 When powered on, the
to. Press the Home button once to send out a reconnect request if necessary.
 To clear the pairing information from the
button for 5 seconds. The status LED will pulse purple to indicate the clearing was successful
 To force the controller into pairing mode, press and hold the start and back buttons for 3 seconds.
3 will automatically try to reconnect to the host it was last connected
L.Y.N.X.
L.Y.N.X.
3
, power on the pad and press and hold the start
8