Page 5
Dear Customer, we would like to thank you and congratulate you on your choice. This new product has been carefully designed and built using top quality materials, and meticulously tested to ensure that it meets all your culinary requirements. Please read and observe these simple instructions, which will enable you to achieve excellent results from the very first time you use it.
Page 6
We recommend that you wear gloves during installation and maintenance. When installing an extracting version (the extracted air is sent outside = Fig. A), it is important to: - prepare an air exhaust hole and duct with a diameter of 150 mm. - use a duct that is as short as possible - use a duct with the least number of curves possible (maximum curve angle 90°) - avoid the use of flat ducts and ducts of different section as much as possible...
Page 7
Fig. 3: adjust the telescopic section of the upper cylinder and fasten it to the bracket (1) using the two M4X12 screws provided. Fig.1 3° Fig.2 IMPORTANT: to fasten the hood to the bracket that has previously been fastened to the wall, see detail (M); if you need to know the height at which the hood must be positioned, see the measurements table.
Page 8
Fig. 4: mount the grease filter on the hood cylinder with the metal handle. Fig. 5: position the glass with the smaller diameter facing down (A).
Page 9
Fig. 6: hook the hinge (B) integrated into the glass to the hook of the male hinge C. Fig. 7: slide the H26 Nylon spacer on the M6X40 screw provided and fasten it, by passing through the hole in the hole in the glass, to the upper hole in the hood cylinder, tightening it by hand or using a tool or coin.
Page 10
Fig. 8: t l i f e l l l i f e i l Proceed to the insertion of the drawer-type carbon filter with the required type of slot system. CONTROLS C D E F G H A) starts/stops the motor at the second speed (the intermediate operating speed B) selects the first motor speed C) selects the second motor speed D) selects the third motor speed...
*Filter alarm: the first thing to do after inserting the plug is to set the hood to extracting or filtering mode; proceed as follows: when the plug is inserted, all the lights turn on for several seconds: in this state, press the on/off button for about 8 seconds until the H LED lights.
Replacement of bulbs: Delicately remove the glass bulb cover with a screwdriver. Replace the bulb with the same type, taking care not to touch the new bulb with your bare hands to void damaging it. Do not touch the bulb if it is still hot! OPERATING PROBLEMS Before calling for service, check these simple things: Why is the hood not working?
Need help?
Do you have a question about the RHWMDB40 and is the answer not in the manual?
Questions and answers