Table of Contents
Advertisement
3
4
2
Figure 46
1. Fuel shut-off valve
2. Fuel filter
Cleaning the Cooling System
Clean the air intake screen from grass and debris before
each use.
Clean cooling fins and engine shrouds every 300 hours or
yearly, which ever comes first.
1. Stop the engine, set the parking brake, remove the key,
and disconnect the spark plug wires from the spark
plugs.
2. Remove air intake screen, cylinder covers and fan
housing.
3. Clean debris and grass from parts.
4. Reinstall air intake screen, cylinder covers, and fan
housing.
1
M–4294
3. Hose clamp
4. Fuel line
38
1
4
Figure 47
1. Air intake screen
2. Fan housing
Greasing and Lubrication
Lubricate the machine when shown on the Check Service
Reference Aid decal (Fig. 48). Grease more frequently
when operating conditions are extremely dusty or sandy.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
How to Grease
1. Disengage the power take off (PTO) and turn the
ignition key to off. Remove the key.
2. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fittings.
3. Connect a grease gun to the fitting. Pump grease into
the fittings until grease begins to ooze out of the
bearings.
4. Wipe up any excess grease.
Where to Add Grease
Lubricate the grease fittings as shown on the Check
Service Reference Aid decal (Fig. 48).
2
3
m–4295
3. Cylinder cover
4. Cylinder cover
Advertisement
Table of Contents
