Table of Contents
Advertisement
2. On lift arms 2 and 3, position the brackets and U-bolts
38 cm (15 inches) behind the center line of the pivot
knuckle
(Figure
8).
Figure 8
1. 38 cm (15 inches)
3. On lift arms 6 and 7, position the brackets and U-bolts
36.8 cm (14-1/2 inches) behind the center line of the
pivot knuckle (
Figure 9
1. 36.8 cm (14-1/2 inches)
2. Lift arm 3
2. Lift arm 7
Note: Rotate the brackets 10° to the outboard side
of the machine.
4. Tighten all the U-bolt nuts to 52 to 65 N∙m (38 to 48
ft-lb).
5. Mount a lift chain to each chain bracket with a screw, a
washer, and a nut, positioning them as shown in
10.
1. Lift chain
8
Installing the Counterweights
No Parts Required
Procedure
Important: When lowering the verticutter reels, take
care to prevent damage to the reel blades due to contact
with a concrete floor or a paved surface. Lower the
transport rollers before lowering the verticutters to a
concrete floor or a paved surface.
You can install the verticutters at any of the 7 locations on
the traction unit.
Figure 11
hydraulic drive motor for each of the locations. For any of
the locations requiring the motor to be mounted on the right
end of the verticutters, install a counterweight on the left end
of the verticutters. For the locations requiring the motor to
be mounted on the left end, install a counterweight on the
right end of the verticutters.
8
Figure 10
2. Chain bracket
shows the orientation of the
Figure
Advertisement
Table of Contents
