1
Figure 15
1. Rear jacking points
Neutral Lock Assembly
When performing routine maintenance and/or engine
diagnostics, the transaxle must be shifted into a
neutral position. The vehicle does not have a neutral
position on the shift lever, so the following steps must
be performed:
1. To lock the transaxle in neutral, rotate the locking
pin 180 degrees on the shift block (Fig. 16).
Figure 16
1. Locking pin
2. Shift the gear selector into REVERSE and then
into FORWARD. Leave the gear shift selector in
the FORWARD position.
3. Ensure that the transaxle is locked in neutral by
rotating the secondary clutch (Fig. 17). No tire
rotation should occur.
1
1
1. Secondary clutch
Servicing the Engine Oil
Service Interval/Specification
Check the oil level before each use.
Change oil:
•
After the first 8 operating hours.
•
After every 50 operating hours.
Replace the oil filter every 100 hours.
Note: Change oil and oil filter more frequently when
operating conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SF, SG, SH,
SJ,or higher)
Crankcase Capacity: 1.4 liters (48 oz./1-
the filter is changed
Viscosity: See table below
3
1. SAE 30
2. SW-30, 10W-30
3. Synthetic Sw-20, 5W-30
23
Figure 17
1
⁄
2
1
2
1
qt.) when