Table of Contents
Advertisement
Rotating the Hedge Trimmer
Handle
1. Press and hold the rotational lock button.
1. Auxiliary handle
2. Rotational lock button
2. Rotate the handle to the right or left depending on desired
cutting direction, then release the rotational lock button to
lock the handle in the desired position.
Stopping the Hedge Trimmer
1. Release the trigger switch (Figure 3).
2. Allow at least 5 seconds for the cutting blade to stop moving.
Charging the Battery Pack
Important: For best results, your battery pack should
be charged in a location where the temperature is more
than 5° C (41° F) but less than 40° C (104° F). To reduce
the risk of serious personal injury, do not store outside
or in vehicles. Charging time will be increased if not
charged within this range.
1. If the power cord is not plugged in to the charger, plug it
into the charger (Figure 5), then plug the power cord into
a power socket.
2. Turn the battery upside down and line up the battery terminal
with the slot in the charger (Figure 5 and Figure 6).
Figure 4
3. Trigger handle
1. Insert battery here
2. LED indicators
1. LED indicators (level of
charge)
2. Release button
3. Slide the battery into the charger until it clicks into place.
4. To remove the battery, hold down the charger, pull up on
the release button, and slide the battery backward out of
the charger.
Note: If you have trouble removing the battery, apply
some dielectric grease to the battery terminals (Figure
7). Do not use any other type of lubricant as it can
damage the terminals.
6
Figure 5
3. Charge/storage mode
switch
4. Power cord plug-in
location
Figure 6
3. Battery terminal
4. Test button
Advertisement
Table of Contents
