Lubrication; Lubricating The Pivot Arms; Lubricating The Gear Case - Toro 22200TE Operator's Manual

Lubrication

Lubricating the Pivot Arms

Service Interval: Every 50 hours
After every 50 operating hours or when the season ends,
lubricate the pivot arms.
1. Move the rear wheel cutting height levers to the
center setting.
2. Disconnect the wire from the spark plug (Figure 10).
3. Drain the gasoline from the fuel tank; refer to
Emptying the Fuel Tank and Cleaning the Fuel Filter.
4. Tip the mower onto its right side.
5. Wipe the grease fittings with a clean rag (Figure 19).
Note: The grease fittings are located near the rear
wheels.
Figure 19
6. Install a grease gun onto the fitting and gently apply 2
or 3 pumps of #2 multi-purpose lithium base grease.
Important: Excessive grease pressure may
damage the seals.
7. Return the mower to its operating position.
8. Close the fuel valve and fill the fuel tank with
gasoline.
9. Connect the wire to the spark plug.

Lubricating the Gear Case

Service Interval: Every 50 hours
After every 50 operating hours, grease the gear case.
1. Remove the grass bag.
2. Remove the gear case access cover.
3. Install a grease gun onto the fitting through the gear
case access opening (Figure 20).
1. Gear case access opening 2. Gear case access cover
4. Gently apply one to 2 pumps of #2 multi-purpose
lithium-base grease.
5. Install the grass bag.
18
Figure 20