Yamaha CDC-775 Service Manual page 11

Function List of Remote Control Transmitter
CODE KEY
00 MODE
01 OPEN/CLOSE
02 PLAY
04
TSKIP
2B TEXT MODE
2C TEXT SRCH
07
YSKIP
08 REPEAT
0A TIME
0B INDEX
0C PROG
0D CLEAR
10 0
11 1
12 2
13 3
14 4
15 5
16 6
17 7
18 8
19 9
1A +10
1B RANDOM
1C OUTPUT LEVEL –
1D OUTPUT LEVEL +
1E DIMMER
1F FILE MODE
2D CAPS
4F DISC SKIP w
50 DISC SKIP q
53 DISC SCAN
55 PAUSE
56 STOP
57 TAPE
58 SYNCHRO
Traverse stop
Tray open/close
PLAY (FOON, TRON, TVON (FEON), SPON)
Backward traverse move. (If inner SW turns on, traverse is stopped.)
(Coefficient set up mode : upper digit down)
Clamp down.
(Coefficient set up mode : lower digit down)
Clamp up.
(Coefficient set up mode : lower digit up)
Forward traverse move.
(Coefficient set up mode : upper digit up)
FOON, TROF (Enter focus search if focus servo is off.)
Checks FL display. (Note 3 : See page 11)
FOON, TROF, TVOF (FEOF) (Enter focus search if focus servo is off.)
Rotates or accelerates spindle.
Decelerates spindle.
Backward 150 TRACK KICK continuously
Returns to product mode. (Tray and Table inoperative.)
Adjustment mode 1 (TR-offset, FO-off set, FO-rough gain adjustment)
Adjustment mode 2 (TR-balance, TR-rough gain adjustment)
Adjustment mode 3 (FO-fine gain, TR-fine gain, FO-balance adjustment)
Forward 1 TRACK KICK continuously
Backward 1 TRACK KICK continuously
Forward 30 TRACK KICK continuously
Backward 30 TRACK KICK continuously
Forward 150 TRACK KICK continuously
Enter coefficient set up mode.
SPON (Spindle servo on.)
Output level down.
(Coefficient set up mode : address down.) (EQSW adjustment mode : value down)
Output level up.
(Coefficient set up mode : address up.) (EQSW adjustment mode : value up)
Checks FL display. (Note 3 :See page 11)
Note :Don't use
Switches servo gain (normal or High). Head amp (GCTRL)
DISC SKIP + (Clockwise)
DISC SKIP – (Counterclockwise)
Measurement the rotating time of the turn table. (Fast speed) (Note 2 :See page 11)
FOON, TROF, TVOF (FEOF) (Enter focus search if focus servo is off.)
All stop. (Focus, spindle, traverse, laser, tray, etc.)
Spindle free (off)
Backward traverse move
CUSTOM CODE = (79)x
FUNCTION
CDC-775
10